Forum Replies Created
-
Posts
-
Re: Beko CDA543FS-2 freezer temp problem but fridge working
cant do any harm
yes normally the freezer keeps going if there was a blockage but its normal practice to do a defrost on these to eliminate ice before you do anything on FF of this type
what worries me is the 10 sec burst from the compressor. sounds like the compressor overload was cutting out but the overload would be doing its job so changing is wont necessarily cure it
Dave
Re: Hotpoint 95490 drum direction
its a simple module with a multiconnector and 2 main terminals and does not reverse the motor its done by the rear timer contacts
Dave
Re: Hotpoint 95490 drum direction
probably the timer
older machine use a reversing contact driven by the motor on the back of the timer.
when it gets to spin these contacts are not used so machine will turn clockwiseDave
timer may be still available
Re: cata selector switch model 65dme40135
try
http://www.spareszone.co.uk/65DME40135- … ctric_oven
Dave
Re: 1973 Hoovermatic Deluxe twin tub
Timer drive
timers where mechanical driven by the flexible drive
Dave
Re: Beko CDA543FS-2 freezer temp problem but fridge working
no you said the fridge was working and since the fridge gets its cold from the freezer it was a possibility that ice may have been stopping the air flow. if the freezer is the same temp as the fridge then its possible to be a sensor or board fault. I am assuming the compressor is ok as you said the fridge was working and i am assuming in this weather with a compressor fault it would be a lot warmer
how long does the compressor run for ?
dave
Re: Beko CDA543FS-2 freezer temp problem but fridge working
this type of freezer relies on cold air circulating with a fan. if the unit is iced up it can restrict the freezing process.
my first try is a complete defrost before you condemn anything elseswitch off, open freezer door for 2 days, then try again
Dave
Re: Leaking door seal – Gorenje WA72145BK
if its clean with no scale build up on the glass and still leaks then the seal needs changing
Dave
Re: Door Seal – AEG Lavamat 6100
if the bands are not damaged they will normally go back on with no problems
Dave
Re: Hotpoint WMEF742P(UK)
with hotpoint i doubt it
ring emw and see if they can programme it
thats the way i did it last time
Dave
