Forum Replies Created
-
Posts
-
Re: SMEG UK80MFX1 Cooling Fan Issue
no i know it does not control the oven
from the picture there a 2 sets of wires looks like 2 blue and 2 white
one set of wires powers the fan
the other set of wires is the energising wiredo any of the wires go directly to the fan ?
if yes its the other wires that have the problem
are you sure you connected it in the same way it came out ?
Dave
Re: Bosch WAQ243D0GB/09 door lock problem.
not ha this fault but will throw a few ideas in
had door hinge been strained ?
any wear on the hook ?Dave
Re: SMEG UK80MFX1 Cooling Fan Issue
from what i can see this reminds me of the system used on AEG ovens. they use a small heater to heat up a switch to turn on the oven.
I dont know the connection but 2 wires are the energizing and the other 2 switch the fan on. my guess is that the energising side is either
A fed continuously because another switch is faulty
or
B you have put a wire in the wrong placeDave
Re: Aquarius FDPF481 Not Heating/Washing Properly
could be either.
you would need to access the element and check its resistance to find out if its ok
Dave
Re: Bosch SMS 69T18AU check water supply error
its a problem with a lot of modern appliances where the water pressure is low
in the area where you live do other people have low water pressure problems ?
you could add a pump to raise the pressure.
Dave
Re: Defrosting fridge
you need to look at the door from the side and make sure the door seal is in contact all the way round. and gaps and moisture will get in
DaveRe: Liebherr 3056 Power board resistor
dont know the board but going by other examples i think it will be like this
the mains comes in through the 100 ohm resistor get rectified to DC
This voltage is then used by a power supply chip like LNK364pn or TYN278GN or similar which then produces the voltage for the board. the 100 ohm resistor is not used to drop voltage and is purely there as a safety device in case of short circuit. not only will it limit the current but will blow to stop fires. it is possible that the shorted cap may have blown the chip as well so if it pops when you turn on change it
Dave
Re: Whirlpool Washing machine door seal 9769B
qualtex show it as 480111100188 superseded by C00311135 or non gen part number dbt 116
gen is in stock
Re: Liebherr 3056 Power board resistor
most of these feed resistors are normally 100 ohms or less. since it is unlikely it will be 10 ohms 100 ohms fusible resistor sounds likely
Dave
Re: AEG F65040IM0P ProClean Error code .00
since it is unlikely that you whole house voltage is going up and down( unless you live in the middle of nowhere) I would plug it into another socket to eliminate the socket its plugged into first
Dave
Re: AEG F65040IM0P ProClean Error code .00
error 00 is a low voltage alarm. if voltage to dishwasher falls below 180v unit cuts out
you either have a faulty supply to the machine or a poss faulty board
Dave
Re: Defrosting a fridge
any fridge that ices up is getting more moisture inside. since the door is the only way it can get in i would take a look at the door seal and make sure it is closing properly all the way round
Dave
Re: EOC6630W hinge replacement
as far as i can see the inner glass slides towards the top of the door enough so it can be removed from the bottom
Dave
