Forum Replies Created
-
Posts
-
Re: Zanussi ZDC37200W heating poorly or not at all
there are 2 elements in one so one may have failed leaving you with half heat
Dave
Re: Beko DRCS76W element not heating
3 points I can think of
1 unless you select a timed programme some dryer wont heat and some wont heat on the timed prog either. machine will be looking for dampness (energy saving )
2 you say only 2 element were working. I assume from that you tried it with the back off. you cant rely on that test as the elements only glow due to lack of airflow and the top elements will glow hotter
3 its the relays on the board that switch the elements on and they can fail
Dave
Re: Whirlpool Top Loader Valve
that’s an American maytag number. whirlpool us says
Out of Stock
(Expected Ship Date January 29 – February 16 if ordered today)see http://www.whirlpoolparts.com/PartDetai … 28/3020530
cant see it on ebay have checked
Dave
Re: Miele W865 Error Code
there is a fuse on the control module
did the brushes seem worn ?
if no prob the reversing relay its a common fault which also blows the fuse .
fuse is a small red or black cylinder approx 1cm high soldered into the boardDave
Re: New world DW60 stopped working
top picture
pull plastic piece down so “U” shape faceing forwardand yes it does take a bit of force it has to hold the door shut
Dave
Re: Beko DRCS68W – replaced heater new one cuts out?
the cutout is detecting high temperatures above the heater. if you are getting this there is only a couple of reasons
1 air flow The airflow across the heater is restricted causing overheat
2 element control where the element is not turned off as the heat rises in the dryer. this can be caused by the front thermistor or the main pcb. either way you would feel the excessive heat inside the drum
Dave
Re: New world DW60 stopped working
the white plastic but you can see has a “U” shape that grabs the loop on the frame. all you have to do is get soething in the “U” and pull it ( down in the above picture)
otherwise strip it out and roll the latch back into position
its not broken its just in the locked position
Dave
Re: New world DW60 stopped working
switch needs to be pulled forward again i use a peice of old wire coat hanger with a 10mm “L” shape at the end. hook it into the “U” of the latch and pull it forward
Dave
Re: hoover dishwasher, salt light
dont worry about the salt ligh it will not stop the unit working
but cant think what might be up with it
Dave
Re: Beko DRCS68W – replaced heater new one cuts out?
if the heater is over heating so
1 are you operating it with the back on ?
2 have you checked and cleaned the condensor ie can you see light all through it
both the controlling thermostats on the unit are thermistors that can be checked by a multimeter
Dave
Re: SMEG BUILT UNDER DOUBLE OVEN DOOR ISSUE
have you rang your supplier of the spare parts to check they are correct
plus i assume the oven door inner glass is fitted
Dave
Re: Stoves Newhome Envoy 550SI, Model No 059054121
have you rang stoves?
they make it so its the best place to start
Dave
