[electrofix]

Re: zanussi zdc 37200w

2 things

1 for anything to work it needs 2 wires. a power lead and a neutral lead. if the neutral breaks you can see 240volts everywhere but it wont work

2 if you have live and neutral at the board then the board is probably your problem

Dave

[electrofix]

Re: Neff S5453X1GB/74 error codes?

with a pop I would open the control board and look for damage

what happened to old board did that go pop ?

Dave

[electrofix]

Re: Bosch WVT1260GB Washer Dryer stops at 1 minute

sometimes they don’t and still it causes it. try disconnecting the heater and tape up wires as a test. it will go through a programme just takes longer as it waits to heat and then give up

did you search forum and see this

http://www.ukwhitegoods.co.uk/help/fix- … t-1-minute

Dave

[electrofix]

Re: Miele water inlet fault:only completing wash with empty

with clothes in machine needs more water so it just may be a time out problem

how quickly does it fill ?

does it work if you try a separate rinse with washing in ?

try
if you still have the old valve and if the coil is ok. pull off coil, unscrew valve stem (if its not bonded) if it comes off you can replace the rubber seal with one from a standard valve like Qualtex val01 or 03 as most of the time these can be unscrewed

Dave

[electrofix]

Re: Leaking soap dispenser, Bendix B/W 103W

its not a common problem on these machine but there are only a few reasons why it happens some of which you seem to have covered like blocked soap hose

possible blocked ducts in the roof of the soap dispenser housing if not turn water off, start machine, the when it asks for water turn it on just enough to get it to fill in a reasonable time

Dave

[electrofix]

Re: Bosch WFX2867GB doesn’t work

you could contact QER or EMW electronics to see if they can repair the board. the chances are the power supply chip has gone on the board if so its easily repairable

Dave

[electrofix]

Re: Leisure dual fuel range faulty door

most likely the hinges but with the lack of info its hard to advise

if you added the model and serial number would be a lot better

Dave

[electrofix]

Re: Bosch WFX2867GB doesn’t work

I am assuming you have no display or life whatsoever

if yes sounds like the main pcb at fault all other faults will give you some lights lit

Dave

[electrofix]

Re: Bosch WVT1260GB Washer Dryer stops at 1 minute

most common cause is heater earth fault but there are others

dave

[electrofix]

Re: adp1520 Diplomat Hob Regulator

from that number I am getting a touch control pcb

if so prob the relay on the board stuck

Dave

[electrofix]

Re: hoover DYN8144

very unlikely to be just the resistor. a lot of manufacturers use fusible resistors to protect against fire. my guess is the power supply chip has also failed

dave

[electrofix]

Re: Brandt oven model FAT24X1U3

well I am only guessing here but judging by the printing

press and hold the + & – buttons and see if clock can be set that way

assume display will flash then use + & – buttons to set

Dave

[electrofix]

Re: siemens int/dryer wt79020eu/01

parts breakdown is easy

http://shop.bshappliancecare.com/

wiring now that’s a bit harder as I don’t have access

Dave

[electrofix]

Re: Electrolux L76810 Error E52

there are 5 machines with the same model. there will be differences so you need to know which one
ie need the product code which ties it to one machine

also you can check tacho with a multimeter connect leads to tacho output on motor plug ( with plug out ) spin motor by hand you should see an output

Dave

[electrofix]

Re: Hoover WMH168D wash programmes stopped

if machine has motor brushes check them although if it is 3 years old they should not have failed unless you wash for the whole street

Dave

[Author]

Posts