Forum Replies Created
-
Posts
-
Re: No lights, no heat in Bush single electric oven
since I do not know the model I cannot be specific but
you mention a display (clock) the clock may have an automatic off position and needs to be set to manual to work
Dave
Re: Russell Hobbs Washing Machine Drum Paddle
have you emailed the site shop?
they list the door rubber for it and may be able to obtain paddle
Dave
Re: I need a compact wet and dry vacuum cleaner.
this post flags up a few problems for me
1 a wet and dry cleaner cannot do both at the same time. if you set it up dry the unit uses filters or bags to catch the dust. if you set it up wet you remove the filters as the water stops the dust and the filters would get wet and water would get into the motor
2 from reading your post it seem you want it to handle wet just in case you children spill something so no that wont work
also you state 6 gallons, that’s a lot so it would be a big unit
Dave
Re: ISE 10 1606W
not seen many ise’s so don’t know this machine
butwhen u say it just pumps out do you mean the pump wont stop or it will just drain nothing else
if you can set a wash programme what happens ?
dave
Re: Siemens Siwamat 2460,water comes but the drum does not t
without a model number I cant check but in most cases of drum no turn problems the motor brushes have worn out.
some more modern machines don’t have brushes but if it has it should be an easy fixDave
Re: Which Marchine
to be honest joke hotpoint. now whirlpool have taken them over it we will see if thing improve but I doubt it
quite often the dearer machines can have bearing changes
Miele can be done but they don’t go that often
some Bosch machine ( you can check here http://shop.bshappliancecare.com/ if you have the Enr of the machine you can get a breakdown and see if it splitsLG can also be done
Dave
Re: Hotpoint hvf344 uk
sound like a pcb power supply fault
if your not good at electronics send both boards to EMW they will check and repair as a pair
Dave
Re: leisure rm10crs range cooker
do you mean the hob as well cause I cannot see the logic of putting the hob through a 15 amp stat
Dave
Re: HOOVER WMH130D-80
what sort of lock is it ?
is the thermal type that takes 3 mins to unlock
or the instant type that goes clunk clunk and opens
Dave
Re: HOOVER WMH130D-80
teach me to read post properly will try again
you have now changed both lock and board and unit is the same
tried to find model but cannot find it even on google
what sort of lock has this one got ?
if tis the old timed type, if you switch off plug does it open ?as Bryan says could be board even new ones can be faulty but would be very bad luck
Dave
Re: DAEWOO DRS30SMI PARTS/SERVICE MANUAL
connect have got part breakdown all be it with hidden gen part numbers
DaveRe: HOOVER WMH130D-80
have u changed the lock ?
if a lock blows the pcb always replace the lock as well
Dave
Re: Elecrolux ER 6822d
have you tried another thermometer as -32 sounds a bit cold but I am not an expert on refrigeration
Dave
