[electrofix]

Re: Candy CDC266 how to get inside?

most of these dryers load from the front so the front panel has to come off
dont forget to remove door hinge and pull out door seal or panel wont come off

Dave

[electrofix]

Re: beko WMB 51021W drains for 5 seconds 3 second spin

sounds like motor tacho magnet or motor triac

Dave

[electrofix]

Re: Smeg Oven Hinges and runner – S1100MFX5

ring servevast they will give you their psrt number and then type in the website
its not uncommon for parts not to be listed on the site against a particular model.

Dave

[electrofix]

Re: Siemens KG32U193GB/06 freezer door seal

it seems to be the same seal on the /05 /07 and 09 models

part number 236672

have you double checked model number ?

Dave

[electrofix]

Re: Bosch/ Siemens SN25M830UK/01 Dishwasher leaks ?

had a couple of the later ones leaking where the plastic joins the base. had to scrap them, no seal listed, and mamouth job to change if it was

Dave

[electrofix]

Re: Bosch pressure switch

not sure if this is one of the later pressure switches

did it click when you blew into it?

if yes its the old type and it will be ok and you prob did not get the right terminals

if it did not click then you have probaly ruined it by blowing into it

Dave

[electrofix]

Re: BEKO DSC85W No Heat

have sent you some info that might help

Dave

[electrofix]

Re: Clearing out old vacuum cleaners.

unless its a good make i would not think so

i just take them to the tip one or two at a time

Dave

[electrofix]

Re: Beko DW450 Door won’t close.

take both baskets out

if its integrated check the outer door is not fouling the works surface

and see if that helps

Dave

[electrofix]

Re: Beko DW450 Door won’t close.

when you try to close the door does it seem difficult to close the last inch

if so suspect the hinges. has the door been strained ie has anythinf fallen on it or a child sat on it causing it to bend

Dave

[electrofix]

Re: Neff U1451B0GB/05 oven handle

no its not bonded

make sure you have got all the screws

if so its prob grease

Dave

[electrofix]

Re: Problem Miele Professional WS5425 MC 13

if the tracks on the pcb are the only damage you could solder wires in their place and cut the old track at both ends to stop any shorts

Dave

[electrofix]

Re: How much????.

a long time ago with a world full of single tubs, twin tubs and maybe even pmc and modules

Dave

[electrofix]

Re: Neff U1722n0gb/02 Fan element

looked at that Martin but that comes up obsolete on qualtex as well

Dave

[electrofix]

Re: CDA CL970IN washer dryer

if CDA is the make ring thme direct sme of their part prices are not bad

but am of the opinion CDA stands for c**p domestic appliances

Dave

[Author]

Posts