Forum Replies Created
-
Posts
-
Re: BEKO CDA751 FS/1 SEAL Wrong Size
i have checked and your part numbers are correct.
there is an old part number for the freezer seal of 4307795700 but is superseeded by the one you have. cant see any part changes so cant be of any more help sorry
Dave
Re: Height reduceable washer dryer
they still list a few may only be on some machines
http://www.bosch-home.co.uk/store/categ … under_kits
Dave
Re: Height reduceable washer dryer
look at bosch they used to do this, think its called a build under kit
Dave
Re: Indesit iwde126 drum keeps filling with water
even i cant fit them they come blank and have to be programmed
try
http://www.qer.biz/servReps.htm
or
https://emwelec.co.uk/both firms can repair you board and reprogramme as necessary
Dave
Re: beko drcs76w not heating
dont forgat heaters wont come on in most modern dryers unless there are wet clothes in it
check the relays on the board that control the heater. common fault on a lot of dryers
Dave
Re: qualtex alternative to oven fan motor C00081589
cant get into qualtex site at the mo but Europart have it priced at £27
Dave
Re: Indesit iwde126 drum keeps filling with water
wel there is only 2 things it can be
1 the valve
2 the boardif the valve had gone i would expect the machine to carry on filling even if it was turned off. so it would flood overnight ect
so with that in mind sounds like a board fault
try this
instead of turning off the feed to stop the water turn the whole machine off at the plug. if the valve is faulty it will continue to run in for a while. it should stop instantly. if it stops its a board problem possible a leaky traic (the electronic switch that controls the valve)
Dave
Re: J Lewis heat pump Dryer, Dead
if power is getting to the pcb i would first check power supply on the board. normally power goes in through a low ohm resistor (47-100 ohms ) then onto the power supply chips. check this resistor to see if its blown
also check, before you touch it too much, if its covered by any extended parts guarentee
dave
Re: wanted… Pcb aeg f35080vi
had a few with this fault but not gat any scrap boards at the mo
had a bit of sucess by taking apart the switches and re-grooving the latch mech inside. the plastic grooves wear with switching on and off so the latch wire goes down the wrong path
Dave
Re: MIELE W827 Washing Machine Trips mains supply
until someone looks at it you cant be sure whats causing this
my first guess would be the heater or the motor but it may not be
all we know for certain is the unit has an earth fault which could be caused by a number of things
Dave
Re: ADMIRAL LATA401AGE
this is a whirpool unit
go to maytag.com select spares
brings up al diags for machine
valve should be part number 352375 site says its 230v
last time i had a similar prob i rang qualtex and got them to ask whirlpool to cross ref american numberDave
Re: bosch srv43a03gb/08 dead pcb
there will be a low ohm resistor as the power goes to the board. normally value under 100 ohm. if this has blown it may be just this resitor or the power chip that supplies the board. dont just bridge the resistor in case power chip is short circuit, it is meant to act as a safety fuse
Dave
