[electrofix]

Re: Zan wm sticking at approx 45 mins

E13 says poss fault water leakage but suggests the following

Drain hose incorrectly positioned; mains pressure insufficient; water fill solenoid faulty; leakage/blockage of pressure switch hydraulic circuit; pressure switch faulty.

sounds more like fill time out problem

Dave

[electrofix]

Re: miele t293 / t294

not sure of model but my my experience of Miele dryers

have you checked relays for operation

you need to check low voltage relay coil voltages. if they are there but no heat the realys are at fault

also it wont heat without wet clothes in it. I take lid off and put a damp cloth over the brush gear

Dave

[electrofix]

Re: creda standalone cooker main oven

is the clock set ?

also are you trying oven with door closed as a lot of creda ovens switch off when the door is open

Dave

[electrofix]

Re: indesit idv 75uk wont run

most likely timer fault

Dave

[electrofix]

Re: Neff 16 Amp ovens

prob is most people would just couple it up to the hob and forget it.

Dave

[electrofix]

Re: o-ring for IKEA Whirlpool dishwasher

this unit is made by whirlpool so parts are easy

email the site shop with the same info above and see if thay can help

Dave

[electrofix]

Re: Miele Dynamic U1 Cat & Dog upright repair

from memory

i think there is a hole at the rear that you push something in to release a catch to remove handle
cant promise i am right long time since i have seen one

when you got cleaner did you have to install handle ?

Dave

[electrofix]

Re: logik frost free fridge freezer not cold

if you blow air up to fridge warm air has to return to freezer. dont do many fridges but i assume there has to be a return duct.
assume you have checked for ice blockages but though i would bring it up

Dave

[electrofix]

Re: Miele Dynamic U1 Cat & Dog upright repair

from the picture i got from google search you will prob find its a complete handle
had one similar with flex break on handle, tried but could not take apart, complete handle only, price we were quoted a few years ago was around £80

give miele a ring and ask if it splits

Dave

[electrofix]

Re: AEG Oven BP3003001M

what worries me is the blinking with a clicking noise. if the clock just needed setting then i would expect no noise.

sounds more like a power supply going into fold back mode

ie power turns on and voltage on the board rises. a relay kick in giving a click. the current through the supply keeps rising till the power supply closes down to stop overload. the current drops ther relay resets and it all starts again

you could check this by measuring the power supply output. look like it may be the green cap on the right of page 1 of the manual ( check voltage on cap if under 70v or so i am prob right if 400v i am not)

in short prob a board fault

Dave

[electrofix]

Re: Zanussi condenser tumble dryer water problem

as you plug the tank in there are 2 valves.

1 in the tank to stop it leaking when removed

2 in the base of the machine to stop the remaining water leak when the tank is removed

sound like this valve is faulty. if it does not open the machine fills with water till a float lifts and stops it turning on the full lamp

if you turn it over the water in the sump may get where it should not be

Dave

[electrofix]

Re: B and Q integrated extractor hood number IHD60HV faulty

if you had the manual you would realise the fuse should have been 3 Amp not 13

if its a simple switch and not electronics then you can split switch unit, find blow track/s, solder wire across blown parts, and it should go again

Dave

[electrofix]

Re: zanussi fridge/freezer

have sent you manual but it does not show you how to dismantle it

hope it helps

Dave

[electrofix]

Re: Food grade water supply pipes

http://www.caterparts.com/advanced-part … 1-2m-St-St

try here

search water hose

dave

[electrofix]

Re: White Knight integrated dryer C8317 not heating properly

sounds like element failure

half heat 1 element full heat 2 elements

so it sounds like element 1 has failed. they come as a pair not an uncommon fault

Dave

[Author]

Posts