Forum Replies Created
-
Posts
-
Re: AEG C3 error code
from manual
leak
poss pump fault
poss wiring faultbut could also be pcb fault
DaveRe: Hotpoint condenser tumble dryer making squeaking noise
look at back of dryer remove plastic sem-circle (2 screws)
in the middle is the drum rear bearing. if its central no probs but i suspect it will be well worn and will have cut a groove in the shaft so the centre of the drum shaft will be lower than it should be
Dave
Re: AEG OKO Favorit 4040: door springs? too old to repair?
i dont know which part of the country you are in but here in the northwest £120 sounds a bit steep
have you tried this website to find an engineer
get him to look and confirm what has gone before you order the springs. as i do he will also put a trained eye on other components to see if they are going
DaveRe: MAYTAG MTD09WH1 852198915010 4 lights flashing
having a look on line i cannot see which lights you mean.
this dryer has lights over 5 of the buttons non of them labelled as abovecan you expand on description
Dave
Re: Zanussi zwx1605 w
from what you saying it does sound like a control board problem
just to clear thing up
when you press start do you hear the door lock go clunk
reason I ask is these door lock do fail but if you get no noise at all then its not normally the problem
also you should be able to get access to service mode ( assume you are holding buttons then turn machine on and hold for 4 secs or so )you could try a long shot it does work on some zanussi machines
disconnect the ribbon cable from board to front display, plug machine in and turn it on for about 5 secs, turn it off again, then reconnect cable. turn back on and see what happen
dont hold a lot of hope on this one but its free so worth a tryas for J8-1 there should be 5v on this with respect to the board ground. but the diag shows that it is also neutral so you cant use earth as a base for this measurement but measure between J8-1 and J8-2
DaveRe: NEFF WASHER DRYER V5340X2GB/06 FD8710 00045 E-05
machine may be filling but it not being detected so machine goes into error
have you looked for pressure bell blockages etc
Dave
Re: Bosch dishwasher not heating SGS69L02gb17
the heating circuit is quite simple and you need to test it all
there is the wiring from the door to the heater
the microswitch on the heater box
thermostat
and the heatermake sure the programme you select heats. a lot of programmes do a cold rinse first. so listen for the soap draw to open this is an indication it is on the wash part of the programme
make sure the heater micro is closing. only closes when wash motor starts
the thermostat on top of the box has 2 parts part 1 85 degree stat part 2 ntc. as far as I know the 85 degree stat is in series with the heaterDave
Re: Bosch SGS45C02GB/11 pulses on and off
its got the hallmarks of a pcb power supply fault. think all these boards use a switch mode power supply so may be chip failing but i would look inside pcb for blown caps. long shot but you never know till you have looked
Dave
Re: hotpoint aq9d69u controll ribbon broke
not done one but i know of the fault so it does happen
Dave
Re: Smeg DW1612C
model is DWI612c not DW1
cap on servast site
http://www.servevastdirect.co.uk/index. … ct_id=1336
from picture looks like 6uF but you cant be certain till you look at the old one
Dave
