[electrofix]

Re: Bosch SMS50E02 check water light on

dont think it will be a heard fix

go to

http://www.bosch-home.co.uk/store/spareparts/search

put your complete Enr in and you should get a complete diagram amd parts listing

Dave

[electrofix]

Re: Bosch Ecologixx 7 wtw84560 – Full Beaker

oh that sounds like fun not seen one yet

Dave

[electrofix]

Re: Discontinued part for Miele oven

how old is this appliance ?

which thermostat has failed ?

Dave

[electrofix]

Re: Bosch Ecologixx 7 wtw84560 – Full Beaker

had this sort of fault on bosch dryers

there is a pump that lifts the water to the top. this has a reservoir that get blocked with fluff
if you remove condenser and look where is comes from you will see part of the floor is removable and fluff traps in there
beat way to access is to take off left hand side of dryer

if its like the few I have seen pump is at the rear left hand side
remove and clean

Dave

[electrofix]

Re: Bosch SMS50E02 check water light on

by the look of the valve on this machine its a complete valve and hose unit
if there is water getting to the valve and valve is humming then is gone
only other thing it can be is inlet filter which if you take valve off tap its in the end

Dave

[electrofix]

Re: WFO 2860 – damaged electrics?

check heater relay on board

could be a blown track or bad solder joint

Dave

[electrofix]

Re: husky fridge thermostat

thanks m8

Dave

[electrofix]

Re: husky fridge thermostat

how did you get it in the box
i had a qualtex ran 100 and could not get it in the box

Dave

[electrofix]

Re: JLWM1203 doersn’t heat the water – no error code

heater is first thing to check normally at the back on Zanussi units
on most Zann units if unit does not heat it just moves on without heating so no error code

Dave

[electrofix]

Re: Siemens HB86k580B M/W Combi

go to

http://www.siemens-home.co.uk/store/spareparts/search

put in your Enr
then download and enlarge diag might give you a clue

hope it helps

Dave

[electrofix]

Re: Indesit IDF125 prob

any appliance that trip the rcd has to have an earth problem

could be a few things including the heater and leaks

Dave

[electrofix]

Re: Bush a126q electronic cards

why would you want to fix these machines?

have you asked supplier if they will do a bulk price on 20 ?

if you need 20 cards it shows hoe unreliable they are so may give too many headaches

what is wrong with cards? have other components caused them to fail ?

Dave

[electrofix]

Re: Bosch new format SBV50E10 wierdness – wont work unless y

not sure but,
From what i have read etc the pump is 3 phase ( therefore has 3 wires going to it) they use the current going to the pump to sense when unit is empty. if pump is getting worn and jamming it will draw more current and therefore board will not sense it is empty

you may have to try the pump change to find out

Dave

[electrofix]

Re: Beko Tumble Dryer DRCS68W Not drying

hi bernie

just seen you post

have the tech info for these if you pm me your email and a quick reminder about model etc i will get them to you
i am away this week but should get it done when i come back if your customer can wait

Dave

[electrofix]

Re: Panasonic NN-A554W Microwave stops during microwaving.

with ref to my warning above about the danger !!!

mag should read low ohms between terms and very high to earth

yes boards do go but most of the time when they do it blows fuses

it is prob a mag failure but you cannot rule out board failure as well as you cant test it without working mag in circuit

Dave

be warned if you touch mag circuit when it on or just turned off you wont get a second chance if in doubt get a prof in to do it

[Author]

Posts