Forum Replies Created
-
Posts
-
Re: Bosch washer
have done one earlier brushes had failed and machine locks out to save motor
sometimes it takes 3 or 4 attempts to reset
knob to 6 o’clock, hold spin speed button , turn knob 1 click clockwise . then release spin button , turn off and on again
Dave
Re: Lux showing E66
not done it but should be ok if it is only relay
have you looked for earth faults? I only say this because if motor gets wet board sees this as a motor triac short. Not sure if heater is live or neutral switched so theory may not apply.
i would connect a lamp to the heater wires and see if it helped
also you should be able to get a reading across the relay if its faultyhope it helps
dave
Re: No model number or brand name in my washer
machine is buit by merloni
could be diplomat, servis or teka
model label is at the bottom behind kitchen kickstrip
Dave
Re: AEG L88810 Tub change.
yes they can be a pig to get out
are pulleys same diameter? If so should be ok if not all the speeds will be wrong
heat. Warm it up with a blowlamp carefully !the bolt has the blue threadlock on it. You want to get it warm so it becomes sticky and not too hot the plastic melts.
hope it helps
Dave
Re: Dishwasher Blowing Main Fuse
when you say main electric fuse i assume you mean the RCD which has the test button on it
if so, The machine has an earth fault but this can be caused by many things the most common of which are leaks and heater faults
Dave
Re: Miele W970 Washer
probably just a faulty inlet valve
as valves get older the rubber splits and the water does not come in as fast so the machine senses it is filling up fast enough
a lot of miele valves can be taken apart ( take off coil and unscrew stem) and some non gen valves ( like qualtex val 01 and 02 ) will do the same ( most of the time ) so you can swop seals
Dave
Re: Miele W526
most machine do an approximate time till you start them and then correct this when the water comes in ( ie water can be very cold or warm )
what you have to ask is does this affect the washing if not then why bother about itDave
Re: Beko DRVT61W Service Manual
if nobody sorts before will access the beko site and download it next week when back at work
will need your email to get it to youDave
Re: Candy Cdi 2012 pulsing
this has got all the hallmarks of a pcb power supply problem
a lot of pcb’s use a capacitor to supply power to the board. its cheaper than transformers but they fail over time.
you are looking for a prob the largest cap on the board normally 1 or 1.5 uflook in here
trade-technical/simple-pcb-repair-tips-t51155.html
for post that i and other have made
Dave
Re: Miele WS5426 washing machine
as far as i know there is only 1 sensor
there is normally a wiring diag to help you in these machines
from the kit europart list 66-ml-05
looks like a hotpoint sensor ( does not mean its swoppable )
but do a resistance test between the hotpoint one and the miele one at the same temp
Dave
Re: Whirlpool American t/d
are you sure no one has been playing with it ?
it should be fairly simple circuits so should be traceable but i think it may have been a diy merchant
take wires off start relay first and see if it runs
maybe some other member has got a diag to help you
Dave
