[electrofix]

Re: Amica AWP510L back

bril thankyou

dave

[electrofix]

Re: Beko Laundry Tech Info

the problem is there is so many but if you give me an email i will send you the ones i have on my desktop

if you want a specific one let me know the model

Dave

[electrofix]

Re: Amica AWP510L back

did you find a back for me ?

Dave

[electrofix]

Re: Negative feedback on repair services

poor areas can also result in not wanting to pay call out charges
in other words tell us whats wrong with it so we can fix it lol

[electrofix]

Re: Smeg SUK91MFX fan oven element not working

have seen the cooker but cant remember specifics

but

assume its controlled by a pcb so are there separate relays for each element if so one could have gone

hope it helps

Dave

[electrofix]

Re: Miele W439 Belt

try and find your local branch of

http://www.fptgroup.com/

see if they can match it

Dave

[electrofix]

Re: Belling IDW604

long shot

sounds like when it draws a large current things go wrong check mains term blocks etc

dave

[electrofix]

Re: DYSON CRO1

yes front comes off quite easily

remove control panel 2 screws disconnect wiring and pressure tube
remove pump filter
remove 2 screws at top and soapdraw

there are 2 torx screws on the left that are akward to get to cause the outer plasic door get in the way
after that the whole front lifts ( needs a bit of coaxing round the filter
after its off there is a plug to disconnect door switch

as for the fault you need to ask why the customer thinks there is a fault. there is a common fault on these drums where one of the drums jam and throw up fault codes.
the back half of the drum is on its own spider so it can rotate on its own. this spider corrodes and pushes the drum forward and jams it. dysons answer is to stop machine changing gear so they alter the software to stop the fault.

if it is this fault the you start a prog ok but 5 mins in when it changes to contra-rotate the drum will jam

ps dyson have just stopped supporting these machines so spares are limited

Dave

[electrofix]

Re: ignis ADL934/1SWH 854593415750

if you want to post a picture i wil look at it for you

Dave

[electrofix]

Re: ignis ADL934/1SWH 854593415750

cap will be where power comes into board

if they have used one its a large grey or blue block with a value of 1uf to 2uf

there will no visible signs of failure

if your board uses a switch mode power supply like on hotpoint wma range there will be a small transformer and therefore not as easily repaired

Dave

[electrofix]

Re: ignis ADL934/1SWH 854593415750

sound like a board power supply problem

see

trade-technical/simple-pcb-repair-tips-t51155.html

see if your board uses a capacitor for a power supply and if so change it

Dave

[electrofix]

Re: Miele W377 heater element

whole front comes off machine

early ones hinge out have 3 bolts round door

later ones have 1 bolt and whole front removes

Dave

[electrofix]

Re: Beko dryer tech if possible.

let me have an email address for info

Dave

[electrofix]

Re: Beko dryer tech if possible.

if nobody else helps will look an beko website for you but dont have time to do it today

Dave

[electrofix]

Re: Whirlpool ADG7461

this has all the makings of a module power supply problem.
bit like a low battery. has enough power to activate the water valve but as soon as it activates the main motor the voltage drops and the computer crashes

look in here

trade-technical/simple-pcb-repair-tips-t51155.html

for post i and others have written for help

Dave

[Author]

Posts