Forum Replies Created
-
Posts
-
if your using it as a convection oven only you can use anything you would use in a normal oven
but if your using microwave as well the metal will stop the miocrowaves from getting at the food apart from the topalso if the metal touches the inside in more than one place you could get lots of sparking
Dave
on that machine you can take the case off as the drum is attached to the base. the suspension is only on the drum
have had to change the rear boot on one that was fun
Dave
just to double check we are on the same page
you say cooling fan and we are not taking about the fan in the oven chamber we are talking about the one that blows cold air to keep controls cool
Dave
you might find a good used motor on Ebay
with a new sealed tub at just under £300 no one is ever going to repair
with the non sealed it is possible to do a bearing swop but you need a kit to put the drum back together as you have to break clips to seperate it
Dave
ok first of all there are about 6 different models with same model number
off the label i need 2 more numbers. normally in little boxes after the model
you looking in box 1 will say SI then box 2 will be 00 or 01 or 02 etc
Dave
well hopefully you can go and pull it out
turn half grill on and see if you get a voltage across 2 wires. put those on the single element and see how it goes. if it fails swop over first 2 wires
that hopefully should work
Dave
you are probably correct if the room is too cold unit wont work
most fridges have a minimum temp below which it wont function properly
on older units the fridge had to get to plus 2 degrees to turn the unit back on. if the room is plus one then nothing turns on and all defrosts
look in the owners manual and see what it says
Dave
no idea without seeing one close to
there is no technical manual on these
have you checked the user manual
Dave
peejay1977 wrote:
Thanks Dave, sounds like a lot of swearing will be done haha
suggest ear defenders for the wife and kids
Dave
