[electrofix]

Re: TurboAir Orvieto Cooker Hood

google search found this

http://www.turboair.com/gb/en/home.php

hope it helps

Dave

[electrofix]

Re: statesmen WM door handle

did google search always the best first try

http://www.statesmanappliances.co.uk/

try this

Dave

[electrofix]

Re: bosch wfb 2000gb 02

its a cable operated interlock
if you pull cable does door open ?
if yes its the mech if no its the interlock

you may get away with lubricating mech as they get stiff when they wear

Dave

[electrofix]

Re: Zanussi Intergrated Dishwasher Fill Fault?

ps if you want the manual let me have an email address

Dave

[electrofix]

Re: Zanussi Intergrated Dishwasher Fill Fault?

try the following

let the machine start and wait till it starts to fill
open door and add a bucket of water if its a slow fill fault ie valve failure it should start to work when water get to correct level

Dave

[electrofix]

Re: BOSCH WTL6103GB/0` FD 8308

check the tubes first the only one i had the blockage was as the water entered the water tank

Dave

[electrofix]

Re: W/pool dishwasher ADG7560/1 fills, then drains, then sto

what fault code does it come up with ?

[electrofix]

Re: Bosch SMS50E12GB/01

if you do a search Bosch E24 a number of posts come up I have selected this one

viewtopic.php?f=3&t=48910&p=249849&hilit=bosch+e24#p249849

Dave

[electrofix]

Re: diplomat adp 8132

its a smeg

do a search for smeg fault codes and reset proceedures

Dave

[electrofix]

Re: Miele Tumble Dryer T5206 professional not heating

if you have to take the drum out there are 2 hidden allen keys in the holes at the back of the drum took me ages to figure that out when i got my first one

Dave

[electrofix]

Re: Miele Tumble Dryer T5206 professional not heating

all access from the front

3 bolts round door and a couple of hidden screws top left hand corner front panel hinges out

could be relay or overheat stats that can be reset ( red button on top )

you will find a wiring diag and info inside machine to help if the last engineer left it there

Dave

[electrofix]

Re: Whirlpool 3RLEQ8033sw1

ps you can reset stats by tapping them on the floor firmly

Dave

[electrofix]

Re: Whirlpool 3RLEQ8033sw1

this dryer works on vacuum

the motor causes a vacuum in the drum which pulls the air in over the element

so you are lookin for

1 air flow problems which includes recirculation of the hot air

2 leaks in the drum seals if these seals leak cold air gets in but more important the air is bypassing the element causing it to overheat

hope this helps

Dave

[electrofix]

Re: Hotpoint Supermatic Twintub 1464

seal goes
check for excessive movemnent in support tube when it wears will leak even if new seal fitted

not a bad job to fix though done lots of them years ago

Dave

[electrofix]

Re: AWM5145 / 5 door boot

thanks allsortd for input

cant be bearings hole is by door lock its like the outer drum was too close to front of machine or the boot had too much depth
some door boots used to have an indent moulded in to miss the lock

Dave

[Author]

Posts