[electrofix]

rocker wrote:Also Make is a Grundig..

yes but its still a Beko

Dave

[electrofix]

do want to check that model no

Dave

[electrofix]

have you had a good look at the pump to make sure its not blown the board

have a careful look at the board and see if you can see any damage. look around where the pump and valve wire is plugged in

Dave

[electrofix]

sorted

Dave

[electrofix]

door lock wiring

Dave

[electrofix]

have you checked the switch to see if its sticking

Dave

[electrofix]

ok sorted

Dave

[electrofix]

let me have your email

Dave

[electrofix]

could be a blockage , a worn drain pump or a board fault

Dave

[electrofix]

these days they use the pump motors as virtual sensors

Dave

[electrofix]

just need your email

Dave

[electrofix]

well as far as i can see there are 8 EF fault codes

you need to put it in service mode to be more accurate

Dave

[electrofix]

no probs but need email add

is it for the same machine if no let me have full PNC

Dave

[electrofix]

assume you checked NTC’s

also have a close look at heater relay for signs of damage

you could swop out the heater realy from another board if you have one

can probably get tech but would need model or commercial code

Dave

[electrofix]

checked all suppliers , no stock

Whats wrong with the board ?

Dave

[Author]

Posts