[electrofix]

if water light is steady its a fill fault

if its flashing it could be any other fault

Dave

[electrofix]

as a PS

Be careful with Bush stuff. Argos own the brand name and often we struggle to get parts

scrapped a 2 year old range last week. badged Bush no spares available

Dave

[electrofix]

Stokeyblokey wrote:Lesson learned anyway, don’t mess if you aren’t 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure what you’re doing – and it only cost me £27.90 with postage

yes luckily its a cheap end unit made by Vestel so parts are reasonably priced

have had various makes come off over the years and it can take while to figure out where things go to get them together again

Dave

[electrofix]

Stokeyblokey wrote:Thanks for the replies!

I think the holes are right but the coil cannot fit over that stopper with the green arrow, it doesn’t fit in any direction cos the arms of the spring are too long.

can see that now your right it can’t

Dave

[electrofix]

well i would say spring end fits in red arrow
spring coil goes around gree arrow

this should be ne complete dispenser but double check before order

https://shop.ukwhitegoods.co.uk/42173012-dishwasher-detergent-dispenser

Dave

[electrofix]

and those repair contracts have to go somewhere, be interesting to see where

Dave

[electrofix]

try this

wak machines

from off press and hold start turn knob ONE “not two” clicks left after about 10 seconds an odd display shows, turn off all now seems ok.

Dave

[electrofix]

found a hit for an EL230 on electrolux

cooker built 1994 so may be correct

have emailed the parts list and breakdowns may give you some ideas

Dave

[electrofix]

adv wrote:no worries a was going to put a picture up .but says to large to up load ?

server constraints

host somewhere else and post public link

Dave

[electrofix]

one way you may be able to check is to drop the case front off and get hold of the heater where the connections fit and push down. if the bracket is there it wont move but it it is not or its mis placed it will flex and hit the drum

Dave

[electrofix]

this is the bracket that should have been clipped to the heater when you put it back

the tongue at the front fits under a plastic lip inside the outer tub

very silly price, would expect gold plating for that price lol

Dave

https://www.ebay.co.uk/itm/294688640100?var=0&mkevt=1&mkcid=1&mkrid=710-53481-19255-0&campid=5338943143&toolid=20006&customid=EAIaIQobChMI3_jfhPqV_gIVjM3tCh3WLwN9EAQYASABEgKVy_D_BwE&gclid=EAIaIQobChMI3_jfhPqV_gIVjM3tCh3WLwN9EAQYASABEgKVy_D_BwE

[electrofix]

cant find out what it looks like and my brain cant remember the model

Dave

[electrofix]

its one of those faults that comes and goes

will be a bad joint or switch somewhere

but where that’s the problem

Dave

[electrofix]

thanks for the update

Dave

[electrofix]

cant think of another problem apart from module fault

have a careful look at solder joints in the module paying attention to any link wire plugs

Dave

[Author]

Posts