Forum Replies Created
-
Posts
-
well first off check power is getting to the board
have you checked socket ?
then look for the fusible resistor normally a low ohm 3w resistor under 50 ohms. see if thats blown
after that come back and report
Dave
have seen on pic of an oven repair where a massive strip down was needed to get at a particular part so i know it happens. cant say on this one as i would probably walk away from it
have you got a full model and serial no for it
Dave
have deleted your duplicate post
well the next thing i would try is a reset
followed by removing door lock and operate by hand
then look for power going to the lock
then check board for damage
oh and disconnect heater as a long shot and try it
you may have done some of this alreadyDave
first you need to find the connection to the board and check resistance values of thermistor
values expected in table below and positioning
dont try to get at it yet as there is a way to do it as far as i can see but too big to post all at once
Dave
but all Qualtex would have to do is say pay on order and all that stops. pay that way with Aswo now so would not bother me to do it with Qualtex if it came to it
Dave
