Forum Replies Created
-
Posts
-
dont like the listing. looks like they have almost been struck off once or twice
https://find-and-update.company-information.service.gov.uk/company/10297193/filing-historycash up front or dont go I would say
Dave
deltra wrote:They even sent a link for me to go to parts centre, havent dealt with them,
thats because its part of Qualtex
this is happening a lot, its roughly £60 a week. If you spend less they will close the account
but its a lot harder when their stock levels are not that good at times
Dave
Qulatex pic just shows just motor
Aswo shows motor and clip
connect shows just motor
bosch website shows clip
If it was me i would expect clip to be in a gen box. I have to add clip to use pattern parts
Dave
site shop should be able to help
https://shop.ukwhitegoods.co.uk/
but they will need the long serail number to make sure its correct. i found over 15 different machines with the same model no
Dave
cant say on that machine but you have to find the pump. a lot of the time its a bulge at the back of the machine at the rear
try removing condensor and put you arm to the back where it came out and see if there is lots of water. not a test on every machine but if its flooded back there you know your on to the problem
Dave
sounds like a timer fault
think its this one but check if you want to purchase
1784050130 Dishwasher Control Module (ukwhitegoods.co.uk)
also I cant promise I am right as i cant inspect the machine but it does sound likely
Dave
the tank on a lot of dryers is at the top but the switch is below. if pump cant pump water up you will get tank full even though the drawe is empty
Dave
and all the manuals just say undo the bolts take it off simples but obviously not that easy in proctice
taken a few motors off zanussi never had a problem as yet
Dave
well the way your talking it sounds like a system fault probably a blockage in the refrigeration system thats sort of reversed the refrigertion process. not an easy fix and wont be cheap
As for the replacement i will tag Don in as he has more retail experience
[USER=”125″]don[/USER]
when you say the beko unit will only work down to 10 degrees they say this to stop the possibility of the freezer defrosting. seperate units ie stand alone fridge and freezers dont have this problem
Dave
see if this helps
E0531: Internal error in the User Interface sensors.
(1) Possible Cause: Cylindrical foam sensor touching another sensor or the board due to incorrect glass assembly.
(1) Possible Fix: Check that the sensors are in the correct position and not forced by the glass. Mount the glass correctly.
(2) Possible Cause: Faulty sensors.
(2) Possible Fix: Replace the User Interface.
Dave
