Forum Replies Created
-
Posts
-
the only thing I can think of is see if the board can be repaired as you have no chance of sourcing a new one
you would have to remove the board and send it away and keep info to be able to correctly re connect
https://www.qualityelectronicrepairs.co.uk/
try contacting the above to ask if its something they may be able to do
or bite the bullet and replace it with a new oven
Dave
dont know if it will fit your model but lots of utube videos on it
looks like part no is 12005744
but check with suppler its ok for your model
Dave
SWERV wrote:According to the Maytag parts website, the part number is 341241. When that is put into ASWO, it comes up with C00312676. You’ll need to double check that.
Merv
putting the model no in Aswo gives you the same result
and Aswo well cheaper
Dave
well pressure sw is about £20 so probably worth a try
assume you have checked pressure chamber for fat build up
Dave
from lux tech
Dave
Most common possible causes • This error is caused by water overflow or leakage, and some of the possible causes are listed below. Since water is present and in contact with almost all components of the dishware be aware that a leak may be located in any of those components in contact with water that make the boundary to the exterior of the washing zone (tub included).
• 1 – Water in bottom tray (the visible effect but not root cause)
• 2 – Drainage problem – drain installation (flap not working) water returning back.
• 3 – Leak from the interior lamp
• 4 – Leak from the door gasket
• 5 – Leak from the external nuts of Comfort lift
• 6 – Water or dirt in the level/ pressure sensor
• 7 – Sensor bracket not in correct position (snap-in)
8 – DW is mounted in a way that the bottom tray is pressed upwards by an object or unevenness of the floor.
• 9 – With main board PB200/300 drain pump defective or not connected.the others dont seem to be fault codes, was thinking it may be info as the computer boots up like sofware version etc
also its talking about the probe module not the probe
can only go by what the fault code description reads as have not seen many of these
Dave
go direct to miele. they wont be cheap but often cheaper then elsewhere
hoses ar £38 and £26 from miele
you can order online
https://www.miele.co.uk/c/spare-parts-and-accessories-24.htm
select full spares catalog and put in model and take it from there
Dave
Thanks K nice to have my diagnosis confirmed
by the looks of it it will need a block and almost every wire leading to it, some i can see listed by connect with a 4 week delivery some are not
how can you tell from Rangemaster part list which one is needed as its not clear which harness goes where and if we have any chance of getting it
serial 7978
this fault is probably because the idiots that connected it ignored the big nuts intended to connect the wire and put it under the screws. boy its been very hot in there
Dave
the wash bars that turn inside. all holes should be clear. get seeds, glass and plastic stuck in them
Dave
could be all sorts
badly placed plate forcing water past door seal, too much foam etc etc
have you checked the bars as blocked hole in the bars mean the rest are at a higher pressure and can push past seals. It also does not wash as good
Dave
washingmachinewoman wrote:
Thought you mistyped the Qualtex price, Dave, such is the difference, but I’ve just checked and £13 it is!
makes you think someone in Qualtex meant to type £31 and got it wrong. but even at that they are well cheaper
order it quick before they catch on
Dave
