Forum Replies Created
-
AuthorPosts
-
electrofix
Moderatorbig problem with hoover is even their tech site is a pile of poo
does it flash on turn on or as programme progresses
Dave
February 4, 2025 at 9:08 pm in reply to: Cookworks microwave EM820CFD-PM – door catch spring #492209electrofix
Moderatorif its just the spring, often you can re shape the end of the spring and re use it
Dave
electrofix
Moderatorwell the tech manual shows a D7 diode
have you got a pic of the board ?
Dave
electrofix
Moderatori would check dryer heater for earth faults
we get lots of problems like this when heaters have a slight leak to earth so check both heaters but the dryer is more likely
Dave
February 4, 2025 at 12:21 am in reply to: Diplomat HTI 1421 Model APM 6517 – help needed with dimensions! #492185electrofix
Moderatorwell you could not integrate it but there is no rule that says a free standing fridge has to be on the floor
Dave
electrofix
ModeratorI have not fitted one but from the videos it looks very fiddly
Dave
February 3, 2025 at 12:45 pm in reply to: Diplomat HTI 1421 Model APM 6517 – help needed with dimensions! #492183electrofix
Moderatorok that makes a difference
I have been assuming its a build under fridge when its a built in fridge
completely different sizes
width is no problem its the height thats the sticking point
Dave
electrofix
Moderator[USER=”125″]don[/USER] you got any info on this ?
As far as I know you should not have much problem with a dedicated freezer outside. The main problem is with fridge freezers where the freezer is ccontrolled by the fridge temperature. These units can defrost the freezer if the outside temp stays around +1 degreesthe only other problem you may have is condensation. In the old days the thermostats were machanical so a bit of moisture was ok. These days of circuit boards mean water can be a killer
Dave
February 1, 2025 at 7:07 pm in reply to: Diplomat HTI 1421 Model APM 6517 – help needed with dimensions! #492179electrofix
Moderatorsounds like an integrated under counter fridge
measure the gap not the fridge
most of them are designed for a 600mm gap cant see any 500mm
Dave
electrofix
Moderatorwell looking that model up it comes up as a heatpump dryer so should not get anywhere near that hot
Dave
electrofix
Moderatorwell from what your saying its time to scrap it
if the compressor is running then that means any sensors have done their job so they cant cause this
you problem now is either a failed compressor or lack of refrigerant
if its lack of gas there must be a leak somewhere to lose and if its a compressor its going to cost and its not a DIY job
Dave
electrofix
Moderatoram afraid the quality of enginners is falling as we retire
am well past retiring age but just enjoy the job (and the income)
Dave
electrofix
Moderatorhttps://www.ukwhitegoods.co.uk/forum…r/46466-tony-r
Tony posts a lot about these type of fridges so try send him a pm and see if he can help
as for the valves I would expect them to have an extenal solenoid which can fail
Dave
electrofix
Moderatorwell if it was child lock you would get more in the display
does sound like a board fault , have you inspected board for damage ?
boards are about £50 plus vat
I would get the board on the bench an power it up if you find no damage. if it does not come on then its likely to be faulty
Dave
electrofix
Moderatorwell done for finding that
Dave
-
AuthorPosts
