Forum Replies Created
-
AuthorPosts
-
electrofix
Moderatoryes there is a load sensor on the legs
check you have not pulled the plug when you changed brushes
if it needs changing current proce of sensor just over £100
but as with all faults it could be sensor or board
Dave
electrofix
Moderatorok was wondering if the brushes were still sparking as they bed in that might be causing the error
try going back to your old way of doingt things. never read that manual and dont know of a machine where you select the programme before you load the drum
the way a lot of machines detect load is through motor current, must say i dont know how miele does it but sensors on the dampers would be the only other way
Dave
electrofix
Moderatoras Kia says
water lamp steady then its a water problem
water light flashing means it could be anything else
not a helpful fault location system
Dave
electrofix
Moderatorwas this happening before the brushes failed ?
Dave
electrofix
Moderatorsurely it must have a warranty
you say the end of the wash
has it completed the whole programme wash, rinses and spin ?Dave
electrofix
Moderatordoes this happen as soon as you turn on or only after you start a programme
you say its about a year under or over ?
Dave
electrofix
ModeratorIf you put the model into qualtex or Aswo it should give you the part.
I am away till Monday so no access to desktop computer
Dave
electrofix
ModeratorAssume water tap to machine is turned on. After that things get harder
Dave
electrofix
Moderatorodd
why are you not pushing the start button ?
Dave
electrofix
Moderatorfrom the look of it its a simple unit
if the fan is running can only be stat or switch
to get spares you will need pnc number as there are over 20 with same model no
Daveelectrofix
Moderatorhave sent service manual
Dave
electrofix
Moderatorassume you have checked NTC and wiring
Think the service manual can be got
Daveelectrofix
Moderatorcan the module be repaired ?
QER are still going
Dave
electrofix
Moderatoryou can easily test the pump
take the lid off
take out water draw
carefully pour a cup of water into where the draw came out
this should send the water back down to the pump and when you turn on it will pump it back up
from what your saying dont think its a pump problem. if it was there would be lots of water down below
Dave
electrofix
Moderatornormally one of 2 things but there are others
1 heating element
2 tacho coil at the rear of the wash motor
if tacho coil has gone you can fit a Beko one as Zanussi only suppliers complete motor
Dave
-
AuthorPosts
