[helo_75]

hello jim 😉

[helo_75]

Re: Bearings on a hpt wt721

Phidom wrote:£60 was never a realistic price for bearing change on a big drum Hotpoint. Also, there was no point stripping it, you only need to take the lid off to determine if it’s a welded drum.

or just look under the kickstrip, if theres a filter its welded, if not its screwed, much less effort!

[helo_75]

did you know that on electronic condenser, on most of the progs, the heater doesnt come on for at least ten mins?

BUT if theres no water going into the drawer, then the pump impellor may have dropped off, and needs replacing, yet if the float is activated, it will turn the heater off

the airing program is exactly that, and wont produce any heat
the drm jammed? that normally a faulty jockey wheel, that’ll need changing to.. that is of course subject to whther the capacitots faulty? was it just jammed, or did it go with a push?

multiples of anwers, just more time inspecting, take off the side panel, all will be revealed.. sometimes a good old look round works wonders!

[helo_75]

faulty water valve?

[helo_75]

then buy a zanussi

and youll have no trouble, guaranteed

or if you can just push a little more,

http://www.comet.co.uk/shopcomet/produc … AEG-T56740

[helo_75]

😀 u only need ask

and ur email will be helpful

[helo_75]

light 2 would suggest an f04 fault

that being pressure switch stuck on empty

does it fill at all? does it fill and not get full?

either way, the machine thinks theres no water in it!!

possible cause? faulty valve, pressure switch or pbc, or pick 2 from 3

[helo_75]

depends on the age.. if its a screwed tub, then its the same scenario as a wma.. some oth the later ones are welded, so that meens tub replacement

[helo_75]

http://shop.ukwhitegoods.co.uk/Tumble+D … ement.html

is what you need
please ignore all the other threads suggesting soldering a 5p thing on from maplins, the only safe solution is to change the element.. hope this helps

[helo_75]

no, its the full heater im afraid

[helo_75]

putting a hot feed will make it abort during rinses

im not posting on this thread again, i think its a wind up

[helo_75]

i think itd be defroeting it with both doors open for 48hrs first

the ice in the freezer would suggest ice build up

which will stop the fan, which stops the fridge from working

worth a try

[helo_75]

your brushes have gone in the motor

common fault

[helo_75]

strange one that

i had one just the other week, and changin the lead and supressor complete and it cured it

those machines are pants

[helo_75]

cut the plug off about 3 inches from the end and youll find itll be ok with a new plug on

seen it a few times

[Author]

Posts