[helo_75]

im sure one of the mods will soon, i dont have the priveledge

[helo_75]

you wanna put this in the trade section?

[helo_75]

lock could well have blown the pcb then

not gonna be cheap

[helo_75]

so the heaters faulty!!

it doesnt need to have a digital screen to display an error code

can i ask how long youve been doing the job

they have a thermistor, and if it was faulty, it would show an error code

[helo_75]

yep, lower element not functioning
could be element, could be pcb

my own did that and it was the element

[helo_75]

its so the door unlockas as soon as the programs finished, so theres no wait

could be either mate, tough call really, ive had both do it, but lock normally cures it

[helo_75]

u got mail

[helo_75]

8? u on a go slow?

[helo_75]

http://shop.ukwhitegoods.co.uk/Washing+ … ement.html

is the heater

[helo_75]

if the drain hose is pushed too far down the frain, itll neve complete a cycle, although youll normally get an error code.. the heater is the only fault that doesnt give ane error

[helo_75]

http://shop.ukwhitegoods.co.uk/Tumble+D … r+Fan.html

will be the problem

if your wanting to look

plug out,top off

looking from the front, its the right hand side panel that needs to come off

i screw on the top, 4 at the rear, panel pulls back and lifts off

the fan is under the grey shroud in front of the motor, next to the pulley

unclip it and manually turn the drum and see if its out of shape, or obstructed

some people take the fan off and run it without for a min to prove its that (keep hands well clear )

hope this helps

[helo_75]

itll be the heater , comes complete with THERMISTOR, but you might wanna make sure its not syphoning

[helo_75]

theres 5 holes, only 4 pads fitted jim

[helo_75]

blocked condenser? faulty valve coil? maybe even a blocked sump trap

itll be one of them

[helo_75]

if it moves and wont spin

viewtopic.php?f=33&t=813

is a good place to start

[Author]

Posts