Forum Replies Created
-
AuthorPosts
-
helo_75
Participantjust wait till you go to the house where it hasnt emptied, and the customer didnt know, and then opened the door……………………..
helo_75
Participantr u sure those codes are right?
1,2,3 &4 signifies a dryer heater relay fault
and its not a washer dryer
your not counting the on/off light in that are you?
helo_75
Participantf10
heater not functioning
might be worth checking the thermostats over the heater! ( rear panel off, with plug out )
January 7, 2009 at 7:41 pm in reply to: Hoover SE230 washing machine won’t move on to spin cycle #273317helo_75
Participantor, better still is the creaseguard button pressed in?
January 7, 2009 at 7:40 pm in reply to: Hoover SE230 washing machine won’t move on to spin cycle #273316helo_75
Participantpossibly.. have you checked the pump?
helo_75
Participanthttp://shop.ukwhitegoods.co.uk/Tumble+D … t+Kit.html
is the right thermostat kit for your dryer
chances are, the pumps ont working, might be worth checking the pump function to clarify if the water is going into the container
helo_75
Participantguys a gimp
his line today was
‘the spray arm only has the serial number embossed on one side.. the arm isnt symmetrical, and therefore isnt fit for purpose.. i want my money back’
first class loser
helo_75
Participantit doesnt actually remove the heat
that fan cools the condenser itselfso the steam is ran across in the opposite direction, so it condenses
doesnt matter much if you run it without that fan, it just wont dry
helo_75
Participanta miele? faulty? surely not
wheres adam hornsby now?
helo_75
Participanti did include the bit about runninig it without the fan on in my initial post, but removed it ( have to consider safety, even though its very simple)
youll probably find the new fan may not be perfect, but it will make a hell of a lot of difference
best of luck,let us know how youve gone on
helo_75
Participantoh, the joys of NOT being in horwich tomorrow
:D:D:D:D:D:D:D:D
helo_75
Participanti was there less than 20 seconds when i realised where i was
and guess where im NOT going to be tomorrow 😀
helo_75
Participantmake hard work of that jim
why take the console of at all?
side panel off, pull it a little forward, slip it on, cut yourself badly putting belt on, side panel back onagreed, 10-15 minsis all it takes
January 6, 2009 at 12:41 am in reply to: Zanussi Dce 5655 Dishwasher Not heating. Very long Cycle ?? #272519helo_75
Participantyou can test for continuity at the pcb end if you are sure you know which wires are for the heater
just disconnect the connecter from the pcb and test, you should get a good reading as long as theres nothing else in circuit
helo_75
Participantyoud be right, its one or the other complete
-
AuthorPosts
