Forum Replies Created
-
Posts
-
i think if you ring them, theyll go a lot of the way towards sorting it out for you
trust me, i work for them
there was some post about a memory effect!
have you tried refitting the original pcb, resetting the program, then putting the new one back in?
yup, itll be a weak pumping compressor
quite common
id throw it and buy a proper one , and not an indesit/hotpoint thing either
bradley wrote:
johnnyj wrote:
Did you swap over the edge conector on the side of the timer, i’ve seen a few forget to do this and you will get a the test programe but will do nothing else, also when you fit the board to get it out of the test programe when the fill starts you cancel programe and it should be set for normal operation , hope this helps JJthis is a dishwasher and has no edge connector on board
pmsl, i wouldnt challenge a hotpoint engineer as to whether he knows if its a dishwasher or nothowever, he’s spot on
i still reckon zanussi machines are at least 5 times better than that crock indesit/hotpoint are selling
if you want better quality bosch
if you got the cash, ise
u do get what you pay for
its on pg 10 of the instruction manual
anyway
Demo Mode
If the machine is on Demo mode ‘D on’ will be displayed and the machine will NOT function.
To reset the machine for normal use:ยท
Turn the power off at the wall.
Push in and hold down the Start/Stop and the Start/Reset
buttons, while still holding down, turn the machine on at the
wall.
‘D off’ will be displayed and the machine will function
normally.
hope this helps
