Forum Replies Created
-
Posts
-
C00195695
is the bitron door lock, which incorporates the relay now, so theyre not interchangeable
used after serial number 60327….
the other thing to look at of course, is the solder joints on the on off switch itself
luckily, its still on, quite often they drop off
you obviously havent had the joyous wd860p pcb scenario yet
good luck
take it off, and refit everything first
one of the naff pieces of plastic will be unclipped
id be trying that first, its quite common
quite often with those dryers, its because the sensor strip has a plastic sleeve under it, which comes adrift
u need to check continuity, between the sensing sleeve and the drum, there should be no contact, if there is, u need to rectify that problem
it wont be a pcb fault, not for that fault
id change the ffd, and take the buner off and clean it
usually its because somethings been spilt on it
and for what its worth, in my paltry 22 years in the job
TAKE THE DRUM OUT OF THE CABINET
why make life hard for yourself?
im sure that model hasnt got a thermostat, but a pcb…but with the way your describing your problem i suspect its more likely to be a statem problem
they were quite prone to corroding on the inlet pipe to the concealed evaprator, they lose gas, and run erattically
if you open the door and press firmly on the back wall , where the ice is, does it flex a little, or is it firm?
how old is it?http://www.comet.co.uk/shopcomet/produc … EDA-S202PW
they are availabe, just be warned they are pants, compared to how they used to be
itll be the heater
plug out…. take off back banjo shaped panel…. if water comes out, the you need to dry it all out with a hairdryer , including the heater
can only but try
