Forum Replies Created
-
AuthorPosts
-
January 5, 2011 at 11:20 am in reply to: Indesit IS70c Tumble Dryer problem. Is it the belt or motor? #340159
helo_75
Participantif that diagram is from the front of the machine, then the belts on wrong!
both sides of the belt should be to the right of the pulley, the left side running on it!!
and yes its unbelievably tight to get on
January 5, 2011 at 12:00 am in reply to: Indesit IS70c Tumble Dryer problem. Is it the belt or motor? #340156helo_75
Participantput the belt on properley!!!
unfortunately, this is quite common
beleive it or not, the belt pulls OVER the pulley (as hard as that is)..
its tight, too tight really, but the belts never stretch and it isnt the motor!
failing that, its worth taking the small acess panel off and checking the back of the drum hasnt dropped off
all too common, on a poorly built dryer
helo_75
Participanttake the back off, theres a cut out for you to press
nice easy repair!
helo_75
Participanthahahahahaha @ error 7
motors fried
January 3, 2011 at 9:41 am in reply to: Beko WMA510W turns slowly instead of spinning: SOLVED :) #339974helo_75
Participantspot on martin… that sounds more like a pcb fault
BUT… what exactly did you have in the machine?
have you run it on empty to see if it spins?
if it spins with no clothes in, its could well just be an out of balanced loadhelo_75
Participantbosch is better in more ways than you could imagine
lol @ the 2 zanussis in 10 years quote btw… more like 1 zanussi a year the rate theyre going down
helo_75
Participanttheres a good chance if u take it apart youll find the fan has slipped down the shaft. it may just want refitting
plug out, split the heater box and look, its the ony way to find out
January 1, 2011 at 6:15 pm in reply to: Bosch WFD 2471 drum not spinning after previous noise. #339904helo_75
Participantcarbon brushes in the motor!!!
helo_75
Participanti think youll find, given the weekly takings, thats not the case
web sales/ click & collect went through the roof
helo_75
Participant2950710100 lamp seal
2954720100 lamp glassi think, the pictures really bad
helo_75
Participant481246068617 is correct
helo_75
Participantu might want to check ambient temperature….
helo_75
Participanto/c – open circuit
ie DUFF
helo_75
Participantitll be one of the pcb’s
now it gets expensive….. cos it coud literally be either
helo_75
Participantfilter isnt listed as a seperate part for that (which would explain why u cant find it)
pump complete however is c00145315
there is a part number for a generic filter kit, with 4 or 5 filters in there, but is as expensive as a new pump
http://shop.ukwhitegoods.co.uk/Washing+ … +Pump.html
is what you require
and by the way, it wouldnt have broke if youd taken the pump off, and removed the pump back.. thats the easieast (and, aparantly , cheapest) way to do it!
good luck
-
AuthorPosts
