Forum Replies Created
-
Posts
-
1st of all, the float doeant turn the motor off, just the heater
it usually leaks because the minute drain hole in the base leading to the pump is full of fluff, but normally it goes into the fan chamber and sprays water over the heater and blows the fuse first!
theres loads round the north west
we visit jim bowens house in the lakes, and we’ve pretty much all been to keith harris samsung fridge freezer
last time we went, he was spray painting cuddles face in the garage.. very funny guy, oh and we been to supersonics house in lytham (syd little)
its more likely to be an incorrect eprom file
the pcb wont be faulty, but there are several variations of that machineive just counted 6 different eprom files on servicenet
‘clarissa martin and macy parker’
excalibur the dog
3 story house?
more chavvy council house filth that wont be happy till they get a new house and an all expenses paid trip to disney in florida
seems a new kitchen isnt enough…..
i THINK id be ignoring the last 3 posts .. none of it made any sense and wasnt helpful.. as engineers we always advise a safe repair.. yes, it is possible to repair the pcb to component level, if you feel confident enough, and want to do that its fine, but we advise a good, safe piece of advice to help you work safely!
anyway, good luck
erm, well, if you put that ‘model number’ in gias website. it says its a new wave washer dryer
usual culprits with those is pump blockages or faulty heaters
sounds like a faulty heater
if your any good with a meter, take of rear lower panel (plug out, and test it ( if the wires not burned off!)
