Forum Replies Created
-
Posts
-
Re: Creda drier tripping fuse box help!!!
hmm, itll be summink to do with the heater
1st thing is to check theres no water in the fan chamber at the back, if there is , drain it and check the float switch
if not then check theres not summink like a bra wire stuck to the heater, they often get pulled through the holes in th back of the drum
further to that, the heater will be faulty
UNPLUG if your to investigate
p.s the fan chamber is on the back of the machine, youll see a banjo shaped cover, with loads of srews around it
Re: Zanussi FLE 1416W
well, you could always try cleaning the blue link ribbon between the 2, or the connections on the board, but more often its the main board to be honest, especially if your door lock is cycling
please, power off if ur looking… safety first
Re: Hotpoint VTD00 Non stop timer
grrrr
id go and have a look 1st
the live wire for the timer motor is pretty tight on those, and have been known to pull off enuff to not make contact when the machine gets warm.
dont be surprised if the timers faulty again, theyre always doin that , especially if its the one that screws to the clip on platethats why they changed it to the one that screws directly to the fascia, and i dont think theyre interchangeable
oh, and thats the product code not the serial numberhth
helo
Re: Zanussi FLE 1416W
and there start your problems
unless your an expert at reading binary code, its damned hard to come to a conclusion
most experts, including zanussi themselves struggle with that model
i have a digital displayboard i plug in to tell me the fault
id call an expert to be honest, i wouldnt start guessin
Re: Creda Model 48345 Concept Halogen
ooh thats a bit extreme
you wont buy a modern cooker with the same quality
still thats your choice
Re: Zanussi FLE 1416W
oh dear thats not good
does it have a digital display?
i.e does it have a window that shows the time on the front panel?
Re: Hotpoint WF620P
most probably the pumps blocked with fluff, clean out sump trap, thatll probably cure it
unplug it before checking
Re: Hotpoint condenser dryer ctd00p
C00194688
theres that one for the fan, motor and cap
and then theres 1703273
which is the front bearing pads and belt ( the kit to get rid of them horrible rattly wheels on th older variants)
Re: Homark oven model 02-700401… not working.
hmmm, well, some ovens dont even have a clock on, and theyre ok
occassionally, customers are happy to leave them like that (bypassed) as long as the conections are tight, and insulated well ( and thats not a comment on your husbands repair skills, it just makes sense, safety wise) , since most people dont use the timer anyway
hope this helps
helo_75
Re: Hotpoint condenser dryer ctd00p
the cooling fan on those machines are so bad, merloni have introduced a kit to cure it
You’ll probably find the fan had warped, and the capacitor did its usual trick of not starting the motor, and of course the heater tripped out
All supplied in the kit ( motor, cooling fan, cap)
In fact, to be honest the new fans arent a great deal better, other than being keyed on the shaft, yet they’re still breaking)
The best place for any merloni drier is the tip, but , remember, they’re helping us to keep our jobs!
Re: Bosch Classixx SGS43A52GB/35 Intermitant filling fault
hmm, u probably go a leak somewhere… does water come from the base when u tip it up?
