[helo_75]

i ALWAYS remove the filter

works so much better, and the toc never trips again

good luck

[helo_75]

god they are a pain when they start like that

does it click at all?

email addy?

[helo_75]

and there goes another thread, turned into ‘lets slag the comet engineer off’

im getting tired of it, its horrible.. its a damned hard world out there, customers are becoming more difficult and the products less serviceable

im a comet engineer, and i will say that all my colleagues are highly trained, multi skilled and very knowledgeable

they are also my friends

if anyone wants to start a ‘lets slag comet off’ thread.. feel free, but be warned it will get messy

were all in the same job, and we all need each other
a lot of you on here i hold in high regard, but its starting to wear thin

get over it

[helo_75]

motor capacitor

or duff motor, or pcb

but either way, the motors not starting

[helo_75]

no

if it is the case, the pcb will be faulty

of course, could just be out of balance

[helo_75]

check the wires arent off the ntc.. seen quite a few do that…

other than that , megger the heater , then its the pcb im afraid

[helo_75]

its not waterless

[helo_75]

deplastering?

enzyme plateau?

quite normal, as chris says

[helo_75]

spot on

take the condenser out, put your arm in and feel for the hole, remove whatever is blocking it

[helo_75]

the doors probably warped

if you open the door, theres a pin at the 12 oclock position, and that operates the switch

i bend the door a little so the pin is nearer the switch

that normally does it

[helo_75]

itll be the fluff filter

remove it and snip the wire to the valve.

problem solved

and will help your statory rights

fit for purpose and all the usual nonsense people use

[helo_75]

http://www.espares.co.uk/part/washing-m … er-bo.html

see im not goin daft

[helo_75]

ill check it monday….

we got rakes on shelf, so they are available

[helo_75]

c00199348?

[helo_75]

ooppss yes it is….

need to have a gas safe guy do it, clocks are around £40 i think
pluss fitting

[Author]

Posts