[helo_75]

yes quite easily

is it gas?

[helo_75]

id be ringing samsung for some ‘advise’

[helo_75]

belt off?

brushes?

[helo_75]

not a valid fault code im afraid

left to right, which light is flashing

ie 1 or 4?

[helo_75]

thought that was a blocked pump?

[helo_75]

need the serial number

faulty selector
everytime
later models had it integrated onto the pcb

try spinning the dial round realy fast 3 or 4 times, it isually clears it short term

[helo_75]

i just cut the filter out and snip the wire to the valve… works better than evver!

[helo_75]

if the solenoid was faulty, it wouldnt progress

buy a soap box top to be sure

[helo_75]

u might wanna check the brushes first

[helo_75]

http://shop.ukwhitegoods.co.uk/Refriger … Timer.html

is what your looking for

its at th rear of the appliance, in a white box behind teh compressor, left hand side

[helo_75]

defrost timer

every time

not expensive either

[helo_75]

personally, id just change the capacitor, theyre pennies

its common for the motor to stop under load, and the cap not start the motpor on reverse

if thats the case, then (and only do this IF thers a fault proven) you can reset the faulty cut out by pushing a pin in the hole in the rear untill you hear a click)

top of , side panel off, right one if looking from front, and capacitor is next to motor

good kluck , and plug out!

[helo_75]

is this the model with the dryness module at the top?

if the drying light is on as soon as you turn the dryer on, the dryness module will be faulty

rather expensive too, and not uncommon

[helo_75]

open the doors, theres screws there…

[helo_75]

check the tacho/ tacho wires on the motor

failing that it will be a pcb problem

oh, or the tacho has fallen off the rear of the motor
defoo a tacho issue

[Author]

Posts