helo_75

Forum Replies Created

Viewing 15 posts - 91 through 105 (of 4,174 total)
1 2 3 … 6 7 8 … 277 278 279
  • Author
    Posts
  • January 23, 2012 at 10:54 pm in reply to: Hotpoint WD860 #367690
    helo_75
    Participant

    Re: Hotpoint WD860

    dont rule out a pcb fault, they notorious for not doing the cooldown cycle!

    November 23, 2011 at 6:27 pm in reply to: hoover auto OPH714D Error code 05 #364201
    helo_75
    Participant

    Re: hoover auto OPH714D Error code 05

    faulty thermister.. could be broken wires, but its usually the thermister thats faulty

    November 22, 2011 at 8:46 pm in reply to: zanussi washer dryer #364126
    helo_75
    Participant

    Re: zanussi washer dryer

    yep, its usually the green valve coil on the top.. if you take the lid off, its really quite obvious

    unless of course, the pumps faulty.

    November 15, 2011 at 5:17 pm in reply to: What is “mains conn supp”? #363672
    helo_75
    Participant

    Re: What is "mains conn supp"?

    personally, id just check the cut out on the heater

    November 7, 2011 at 4:26 pm in reply to: another one bites the dust #363195
    helo_75
    Participant

    Re: another one bites the dust

    nah, u should know me better

    October 5, 2011 at 7:52 pm in reply to: Candy GO 1482-80 #360680
    helo_75
    Participant

    Re: Candy GO 1482-80

    known issues

    name it

    faulty selectors not selecting right programme

    spontaneously combusting tubs

    door locks blowing core boards for no reason

    low insulation on heaters causing e3 (VERY COMMON)

    poor motors that go bang for laughs

    unpredictable fault code of e05 (thermistor faulty/broken wires)

    oh, and the worst one, which i see a lot of, is obstructed pressure vessel which is a pig to clean out as its integrated into the tub

    October 5, 2011 at 7:41 pm in reply to: condenser tumble dryer #360686
    helo_75
    Participant

    Re: condenser tumble dryer

    failed felt seals, front and back.. simple really
    possibly a blocked condenser

    September 19, 2011 at 8:31 pm in reply to: Name That Burnt Out Wreck #358633
    helo_75
    Participant

    Re: Name That Burnt Out Wreck

    its a wjs1387w

    now what do i win

    September 14, 2011 at 2:11 pm in reply to: Hoover SE 234 – 80 #357954
    helo_75
    Participant

    Re: Hoover SE 234 – 80

    ooh no, hang on, thats easily sorted

    open the door, take off the band round the door seal and peel it back.. the black hose is attatched to the tub.. luckily, its u-shaped so if you pull it off the car should be in there

    September 14, 2011 at 1:17 pm in reply to: Candy GOF462-80 #358797
    helo_75
    Participant

    Re: Candy GOF462-80

    erm, are you sure its not just the selector on the pcb?

    quite a common fault on those

    spin the control knob round 6 or 7 times really fast and try agai

    September 6, 2011 at 10:20 pm in reply to: Hotpoint FF187EPL Thermal fuse? #358409
    helo_75
    Participant

    Re: Hotpoint FF187EPL Thermal fuse?

    yep the toc come swith the defrost heater

    sorry

    August 31, 2011 at 11:20 am in reply to: Haier 7KGA+A error message #357897
    helo_75
    Participant

    Re: Haier 7KGA+A error message

    for a ‘fully qualified electrician’ that was a poor answer

    ill give it 4 washes

    August 25, 2011 at 8:50 pm in reply to: hoover vhc391 #357764
    helo_75
    Participant

    Re: hoover vhc391

    had a few.. usually pcb

    August 18, 2011 at 7:54 pm in reply to: hotpoint boots #357450
    helo_75
    Participant

    Re: hotpoint boots

    different drums, different sizes depending on commercial codes

    welcome to our world

    August 17, 2011 at 9:18 pm in reply to: comet #351676
    helo_75
    Participant

    Re: comet

    incidentally, no1 who is/was employed by comet has signed an ‘oncall’ contract, there isnt one, yet!

    we were all put under consultation some time ago.. verbally, and that all got stopped when it all went tits up and the service center business/restructure came to the fore

    the beko mods, and the upcoming bosch dishwasher work that british gas screwed up will help put service into profit, hopefully proppin up retail in dark times

    and if your mate has a ‘comet’ van, then id smell a rat, there shouldnt be any of them they were either rebranded or changed

    hes more likely a ppr guy, and theyve chucked an old van at him to see him through while he makes a mess of the beko mods

  • Author
    Posts
Viewing 15 posts - 91 through 105 (of 4,174 total)
1 2 3 … 6 7 8 … 277 278 279