Forum Replies Created
-
Posts
-
id be checking the thermostats over the heater first
plug out, banjo shaped rear panel off, the thermostats are over the heater
other than that, left to right, first light being 1, which order are they flashing ( i.e 2 and 4, or 1 and 3 etc)
hopthis helps
itll be the brushes
take the motor off, and inspect them properly… easy to change, and well worth it
is it more vibration?
the fans usually the cause of noise on zanussi dryers
the bearing can be inspected at the bac, just remove the access plate
there is no better test of anything than a mulitimeter/megger
this is becoming more and more common… people reading other forums and concluding things that arent the case
obviously, youve run the machine with the thermostats bypassed .. its dangerous and wreckless
u may well find the cure for your dryer is more simple than you realise…
more recent dryers are lower quality than the one you have, and that should be a considerationalthough saying that, they do work slightly diff to the usual boards, you need to turn the knob to the 12 o’clock position (off) if it doesnt reset.. like i say, pcb failure
100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} board failure
need smart card,reader and low end adapter… or give emw a call
