Forum Replies Created
-
Posts
-
Re: SIMPLE PCB REPAIR TIPS
Electrolux EWM1000 Washing Machine Control Board
Symptoms: Machine goes dead after a few minutes regardless of program or if it is running.Cure: Replace the microchip at position U5
Jem
Re: SIMPLE PCB REPAIR TIPS
Hotpoint/Indesit/Merloni Dishwasher Bit100 PCB
Symptoms: Little to No Heat, Heating Timeout ErrorCure: Replace the 2 ringed capacitors
- 0.022uF 330VAC Capacitor
Jem
Re: SIMPLE PCB REPAIR TIPS
SMEG Dishwasher
Symptoms: Little to No Heat, Washes forever, Pauses and Bleeps every couple of Minutes.
Cure: Replace the 3 capacitors ringed in the second imageJem
Re: intergrated dishwasher BF162
If it is a BFI62 and If that is the heating time out error then try changing both of the X2 suppression capacitors on the board as they will cause this error – (I will be putting this in the PCB repair tips later along with some other boards).
Jem
Re: Electra AWM1100A – 30 second Spin
Module came back as no fault found.
Anyone got any information on these?
Jem
Re: Indesit WIXE127 – No Response From Buttons
Well just to finish this one off.
Both boards came back from EMW as no fault found, however when I changed the top board for a second hand one that I had in stock the machine started to work again.
Jem
Re: Whirlpool ADG2900 (854276201710) Element
Thank you John
It does look like the same part so i will go with it and hope that it is especially as it is half (or less) the price of the whirlpool one and not special order.
Jem
Re: Hotpoint TCD970 – Blocked Condensor Error
Thank you – it has given me some more thinking to do.
Jem
Re: Whirlpool 3rlsq8033swo toploader
I think that that will be part no: 481953268533 – (taken from the diagrams of another of there top loaders but I think they are all the same basic machine)
Jem
