Forum Replies Created
-
Posts
-
Re: hotpoint wma66 no drum action
going back to previous post there was no sign of damage on control mod its just good that i happend to have both boards on the van to try
Re: hotpoint wma66 no drum action
Had same fault today turned out to be control mod but as jim said check motor plug wiring
Re: h/point dw fdm550
there is a problem with door harness routed over rather than under a support at bottom of door causing damage to harness so i have heard
Re: Indesit WIXL146 Trips electric as soon as socket is swi
I concure with previous post been down this road before if you have similar old board not working you could try it to test even if its not prog for this model it should prove if its at fault i know you have done it but it still shouts mains lead suppressor
Re: Indesit IDL40 UK.C Not Drying
did you remove front panel and check board heater connections burning .also the stat/ntc is mounted on the inner door panel 2 black leads from board to ntc will help you locate. its common for it to become detatched
Re: hotpoint wmt02 p
check harness down front panel for chaffing on corncrete weight also cable ties can rub through insulation at same area. Remove module and clean off all black dust tooth brush does the job i take it you have checked there is nothing in the filter .If still no joy board from EMW
Re: Hotpoint aqualtis aqxxl129pm uk
only one motor for that model so tacho read seems odd and cheapest option
Re: Hotpoint aqualtis aqxxl129pm uk
sounds like relay on the main board used to be a common prob on wd models but didnt cause lights to flash and it didnt cause any prob with pump they just stuggled to rotate
Re: Hoover HNL-7146-80 Washing Machine
if this is the model with the pump fitted below soap draw its prone to leaking onto pump causing short and and blowing board not alway visible
Re: Hotpoint TDC30P Condenser tumble dryer with water leak.
Thats the place to look as johnny said i have done this on a few of these just reseal with silicone make sure you use plenty i have had to do it again on one no fun to have to go back
