Forum Replies Created
-
Posts
-
Re: will i wont i???
I think it would take someone very brave or with low commitments to start out now, I did 2 years ago and like expertcat am on the verge of jacking it in, really struggling & making far less than when i was employed, tough decisions ahead this year, i may well be out of it in the near future, really soul destroying after 14years of hard work!
Re: Hotpoint BWD129 – Not emptying – How to remove filter co
no,. what you should have said is, if the pump is clear then the filter will easily unscrew, there is no problem with removing them at all, no different to many other machines filters, if its stuck its blocked!!,
Re: Hotpoint BWD129 – Not emptying – How to remove filter co
as iadom has already mentioned, the only reason it will not unscrew is if there is something left in a pocket that is jamming it, any unscrew filter will jam if it gets wedged with foreign objet
Re: HOTPOINT WD440
yes, you will have seen it last time, the motor is at the back of the box, fan blade inside, you may see the scrape marks inside if it has slipped & is rubbing
Re: WIDL126S Eprom location?
Hi they were trying to get you on the direct debit, the £99 repair is garanteed for 12 months!!, (the whole machine is covered for 14 days), also modules are always held in abundance so should be fixed on first visit, hth
Re: Thorny Issue No1
Hi, several years ago i applied to join the police, i had a very nice letter back saying how impressed with my application they were, however there were no positions available for me to apply for at the time, (even though a recruitment drive was on), and advised me to try a different areas force, i spoke to a friend who is well placed, who spoke to someone else, the ‘unnoficial, of course’ reason my application went no further was that too many of my ‘type’ had applied and i did not fit the ‘crteria’ that the current recruitment drive was trying to aim at!!!!
Re: INDESIT WG830 TPG
i dont have partfinder at the moment but think bearings are C00090555?, dont even try to fit a new back half, i had one ordered for me before & there is no way they will fit, old front half will have warped out of shape with age
Re: Hotpoint Aquarius WF250 Fault Light.
light 4 is motor triac fault, on the module, as this is a 1500 spin machine, you say you tried 3 motors, were they all 1500 motors? (there are many different motors for hotpoints, this one is only fitted to 4 machines so you would have to change it for the exact motor) the most likely cause will me the rear module, again you say you have changed this 3 times, where did you get them from? as they to are model specific, fitting one from a different machine will not work correctly,
the only other problem is often the motor plug wires break inside the plug, look like they are connected but not making a contact,
however, unless you are sure you have all the origional parts back onto the machine i would urge caution, as even fitting a pressure switch from another machine can have dangerous outcomes!Re: Homeserve Franchises?
all sounds good to me, if i can have 2 fanchises maybe ill scrape a living after all 😆 😆
