Forum Replies Created
-
Posts
-
Re: Contract Work Rates
you have very ggod providers then, as im just starting, your lowest is £6 higher than my highest! and double the lowest|!!!
Re: Contract Work Rates
thanks, ill take a look in the week when ive got a few hours spare from running my butt off 😆
Re: Indesit C1300 dead in the water
Hi thermostats work by the gas contained in the phial changing pressure under varying temperatures, this then operates the stat at the correct running, the icing in the fridge would depend on wether it was all over icing (possible stat jammed on) or if it was more of an ice lump then may have been a blockage in the gas system pipework, either could have caused a compressor failure eventually, relay failures are rare but the contacts to the compressor may have burnt out, if the compressor itself had failed/jammed you would normally still hear a slight ‘click’ when the unit was swithced on
Re: Hotpoint wma32 module config
unless you ordered them pre-programmed one board can fit about 12 machines so need to be set up to fit the programmes on the machine its being fitted to, i wouldnt worry, if they were wrong you would have found out the next day 😉
Re: Hotpoint wma32 module config
Hi the programming for a WMA32 is as follows
Switch to OFF
Press & Hold ‘Super rinse’ & ‘Rinse Hold’ whilst turning dial to ‘K’
continue to hold for 5 secs untill ‘super rinse’, ‘rinse hold’ & ‘rinse & spin’ flash
Press ‘start’ for 2 seconds, all led’s go outthen for WMA32 turn dial back to ‘D’ press start, (super rinse led lights)
turn dial to ‘A’ press start, (rinse hold lights)
keep dial at ‘A’ press start again (super rinse & rinse hold light)
turn dial to ‘E’ press start, (rinse hold led on, super rinse led flashes)rotate back to ‘A’ then turn through all settings, Final Spin light should go as follows for each dial position
on,on,off,off,off,on,on,on,off,on,off,on,off,on,offRe: ECB Tripped!
hi, could be thermistors causing temp probs, i’ve been fixing these for many years and never had one causing trips, but theres always a first time!
Re: WMA35
heater failure on these is rare but worth checking, more likely would be motor unfortunatly
Re: Indesit possible F17 fault
led 4 flashing is a triac failure, will fill for few seconds then do system check, pick up the triac fault and flash no4, sorry, looks like another great module bit the dust
Re: indesit wixe 127
yep, the wixe127 comes out of test/demo mode the same as hotpoints, remove plug, hold in on/off & start/reset keep pressed & plug back in, should then show Doff on display
