Forum Replies Created
-
Posts
-
Re: Hotpoint t/Dryer condensing -TDWSF83B EP UK – no heat
One more reason to dislike Whirpool stuff, heater and stats complete, C00325945, a cool £77.00 list price. 😯
Re: Zanussi washer dryer fault code? E20?
E20 faults are drain related, you need to enter diagnostics mode to get full error code.
Re: BOSCH washing machine reset HELP!!!
There is also a later reset that is different, on here somewhere but not sure where.
I think it involves a single turn of knob to left or anti clockwise?
Re: hotpoint dryer cdn7000 trips fuse box
DOH, found it now, showing my age, I was entering CND in Partfinder, I guess a lot of you younger ones won’t remember CND. 😀
First produced in 2014, surprised it’s still on sale.
Re: Naff Oven Lamp Holder
Following THIS advice might help as well. 😉
Re: Hotpoint LTB 4M116 – Foam filled and error lights
Don’t have the error codes for such a recent machine but overdosing or spilling rinse aid into the tub will cause major oversoaping which may have flooded the base.
Lights 2+4 on the previous models indicates. Heating circuit, heating element, wiring connections, module, relay, pressure switch.
Re: Zanussi D/W module?
Strange one TBH, not seen this happen before, mainly been heater relay contact problems.
Door switch and door latch both fine, switch on and the power light comes on above the pcb but none of the buttons have any effect, no other lights come on.
Customer says it has been like this for a while now but occasionally will work and complete the cycle perfectly. ❓
I couldn’t get it to come on at all.
Re: Zanussi D/W module?
Oh dear, one very dischuffed customer, they have just had a new stone flagged floor fitted right up to this dishwasher without removing it first, a big hammer will be needed to remove it. 🙁
Re: Hotpoint BF41 leaking from door during wash
A split in the seam of the lower spray arm near the ends is a common cause of this.
Re: Indesit WIDL102 – Rapid Flashing (5+2 lights) too hot?
20 k? @ 20°C
Would not cause the heater to blow though, they are weak enough to go on their own and do quite often.Re: aquarius tcm580 going cold after 2 miutes
Not had problems on this model but this stat did occasionally fail in this way on the previous model of condenser dryer, that is cut out after a few minutes.
