iadom

Forum Replies Created

Viewing 15 posts - 2,116 through 2,130 (of 25,656 total)
  • Author
    Posts
  • in reply to: Ariston built in oven #442194
    iadom
    Moderator

    Re: Ariston built in oven

    There is a link HERE to an Australian web site. You can download a pdf for the FZ51X which might be very similar or even the same as your oven.

    in reply to: Ariston built in oven #442193
    iadom
    Moderator

    Re: Ariston built in oven

    There is an FZ51, are all the markings completely rubbed off the facia?

    in reply to: Ariston built in oven #442192
    iadom
    Moderator

    Re: Ariston built in oven

    There is no Ariston FX51 listed in the official parts information???

    in reply to: WTA 2017 conference #441997
    iadom
    Moderator

    Re: WTA 2017 conference

    kwatt wrote:Sorry Bob, that was a quirk in the dates I missed… D’OH!

    Sorted now though.

    K.
    Is that why it says ‘get ready for the spring 2016 conference’ at the top of the mailshot I have just received? :rotfl:

    in reply to: E21 – AEG Lavamat L75470FL – Not draining? #442170
    iadom
    Moderator

    Re: E21 – AEG Lavamat L75470FL – Not draining?

    There is a low cost alternative HERE

    I am not sure if our forum store ships parts abroad but a Google for that part number or the very expensive manufacturers current part number which is1326911003 may give you some alternatives.

    PS. Even company authorised agents do not have access to pcb level circuit info.

    It is fairly common for this type of pump to fail in this way after several years of use.

    in reply to: Logik Washing Machine l612wm15 fault #432314
    iadom
    Moderator

    Re: Logik Washing Machine l612wm15 fault

    Bear in mind the first post in this thread was two years ago. 😉

    in reply to: Hotpoint Ultima WF860P #442104
    iadom
    Moderator

    Re: Hotpoint Ultima WF860P

    It might be a good idea to remove and thoroughly clean the detergent dispenser drawer and housing. If your cold water pressure is high you could find that turning it down a little using the tap to the machine fill hose may stop the leak.

    in reply to: Hotpoint Ultima WF860P #442102
    iadom
    Moderator

    Re: Hotpoint Ultima WF860P

    You cannot remove the outer case, only the small lower back panel and the front panel can be removed.

    It is possible to run the machine to look for leaks with the rear back panel off but you cannot run the machine with the front panel removed.

    in reply to: Servis oven door? #442101
    iadom
    Moderator

    Re: Servis oven door?

    I did tell her that was the likely situation, thanks for checking.

    in reply to: Hotpoint TDWSF83B turned off while drying #442074
    iadom
    Moderator

    Re: Hotpoint TDWSF83B turned off while drying

    Just had a look at the parts diagrams, it is a Whirlpool dryer, no sign of a user accessible reset button.

    in reply to: Hotpoint TDWSF83B turned off while drying #442073
    iadom
    Moderator

    Re: Hotpoint TDWSF83B turned off while drying

    As this is a very new machine and possibly a rebadged Whirlpool we don’t have any ‘reset’ information or for that matter know if it is a common fault.

    Had the load been spun correctly first or was it very wet?

    in reply to: Bosch Exxcel 1400 Express WFX2868GB #442062
    iadom
    Moderator

    Re: Bosch Exxcel 1400 Express WFX2868GB

    If the drum does not rotate at any time then the motor brushes are the first things to check, after removing the mains plug of course.

    in reply to: Customers unusual requests #441971
    iadom
    Moderator

    Re: Customers unusual requests

    Don’t you just love little old ladies, one once asked me if I could go into her bungalow attic to rescue a trapped bird that had been tweeting away all night.

    It was the batteries in her smoke alarm that needed replacing. 😆

    in reply to: Whirlpool to do a recall on Hotpoint dryers #431564
    iadom
    Moderator

    Re: Whirlpool to do a recall on Hotpoint dryers

    Methinks there was more than a touch of irony in boselectas post. 😉 😆

    in reply to: Discontinued washing machines #441889
    iadom
    Moderator

    Re: Discontinued washing machines

    That’s not his web site Steve, it’s a long established American site. 😉

Viewing 15 posts - 2,116 through 2,130 (of 25,656 total)