Forum Replies Created
-
Posts
-
Re: dryer fire risk
The thing is that it isn’t really a safety ‘recall’ , it’s a free modification. 😉
Re: Hotpoint tumble dryer CTD00 drum not turning
Your machine can have a 7.5, 8.0 or even an 8.5 uf capacitor. The rating is on the side and all of those are in the shop.
Simple change over.
Re: Hotpoint tumble dryer CTD00 drum not turning
It needs a new capacitor, but of more concern, have you checked your appliance on the Hotpoint/Indesit web site. I am pretty sure you have one of models that is the subject of a massive nationwide ‘recall’ due to a fire risk.
Check it HERE
Re: one advantage of Whirlpools take over of Indesit…..
Mine has just dropped through the letterbox. 🙂
Re: one advantage of Whirlpools take over of Indesit…..
And no actual parts diagrams that I can find.?
Re: Carbon brush wear
How long between changes?
In 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of cases it means a new motor sadly.
Re: Creda Reflection 48196 – Turns off when for no reason…
The only cut out I can see is for the top oven and that should still keep the small cooling fan running.
When the display goes dead can you still run the top oven?It does point towards a breakdown inside the main control unit which at around £88 is possibly a little too much on an oven that already has lots of components listed as obsolete. 🙁
Re: dryer fire risk
Not sure if they will supply to trade yet, almost 12 months behind and counting with their own and subbed work.
The whole back panel is replaced, sometimes the complete drum as well depending on model. There is also a pop rivet that has to be drilled and fixed through the back of the drum.
Can’t see it being cost effective for you to replace the complete back and possibly the drum as well TBH. ❓
Re: Hotpoint WT721 Strange F-08 fault
The electronics will self test and throw up an error code for heater faults even when set to spin.
Re: AQXXF149PMUK
Correct part number should be C00119223 which should come with a large amount of wiring harness.
Number you have is for a different model.
Jim.
Re: AQXXF149PMUK
Off for a game of squash shortly, will check up on my return if you haven’t had an answer Lawrence.
Jim.
Re: substituting timers
Re: Hotpoint 9605 top loader.
The red glowing ring around the knob was on 1501 it looked good but was removed on the 1502. On the earlier 1500 there was a 15watt bulb behind the facia that lit up behind a square window.
Re: Hotpoint HULT 943 – door doesn’t open
F06 (F6): –
Door lock fails to close / open, door lock PTC triac open/ closed, mains frequency signal fault, mains power signal fault.
– Check for water leaks that may affect connectors J004 or J11
(three-phase) causing the relative contacts to short;
– Check Door lock terminal board (any problems due to
aggression caused by manufacturing chemical residues that may
cause short circuits);
– Check J004 / door lock wiring;
– Check door lock;
– Renew PCB.That is the full list, sadly the Indesit electronics in these machines are known to be very flaky and are often taken out by faults elsewhere. 🙁
