Forum Replies Created
-
Posts
-
Re: the daft things engineer do !
Can’t be as bad as fitting a fridge door inner liner in the house next door to the one I should have done. 😳
Re: Indesit IDL50 3rd LED Blinking
The numbers on the circuit boards mean nothing as far as parts identification goes and the parts recognition software we have is for UK sourced machines only. 🙁
Re: Hotpoint wt960 inlet valve
Just ease them up slightly with a flat bladed screwdriver and turn them to the position you need. Or if needed you can remove the solenoid completely and turn it round ‘end to end’ to reposition it.
Re: ISE 1606W fault
Age has nothing to do with it. 😉
Serial number on my 1606 is as good as new.Might be something on the back as well.
Re: Hotpoint wt960 inlet valve
Checked again and Partfinder is wrong. 😕
Try QUAVAL 32 from Qualtex.
Or look HERE
Re: Fresh Paint
Apple don’t always get it right then. 😆 Tis fine in landscape view though. 8)
Oops, I see what you mean about the Smilies.Re: Indesit IDL50 3rd LED Blinking
Wrong model number, could it be an IDL500 ?
Error code is a faulty ntc which is hard wired to the control module, a few different versions of this machine including a Chinese made one. :rolls:
All the numbers from the rating plate on the side of the inner door needed to ID but at least one of these modules is around £80.00
Re: BEKO WMP652W – Burning smell and tripping electrics
Don’t waste your time, the motor is shot ( and expensive). 🙁
Re: Tdc60 condenser dryer
Not much else you can do without a wiring diagram TBH. Could be dryness module which is very expensive, could also door switch, control switch or a wiring break somewhere.
Re: Hotpoint FDL570 Flashing lights
Heater is part of main pump assembly, cost around £50. part number C00256527.
