Forum Replies Created
-
Posts
-
Re: Aquarius 6kg will not empty
No, if EMW repair it then it will come back as it left with the original settings intact. I would advise a very careful check of the wiring cables from the pump to the pcb and also check the main wiring harness that runs from the motor to the pcb, it can chafe on the large concrete weight at the front of the machine and cause pcb problems.
Re: Aquarius 6kg will not empty
Pump unlikely to be faulty, Google for EMW pcb repairs, send it to them to test/repair.
Re: Aquarius 6kg will not empty
This machine does not have Indesit electronics in it so no reset needed. As already mentioned the pump is fed directly from the pcb.
You need to check the wiring from the pump to the pcb and the visibly inspect the components on the pcb.
Re: Aquarius 6kg will not empty
You posted whilst I was typing. 🙂
This model is before the awful Indesit electronics so not usually a pressure switch fault.
Also the electronics on these are fairly reliable and don’t suffer from this fault very often. Does the old pump look burnt on the windings in any way?
Edit, checking the diagrams the pump is fed directly from the pcb, it does not go through the pressure switch, if the wiring from pump to pcb is intact the examine the components on the pcb, you may find a blown triac. 🙁
Re: Aquarius 6kg will not empty
Model essential as Andy says, on some models the pump will not run if there is no water in the drum. Also the later pressure switches need to be reset if the machine has been tilted to repair etc.
If the original pump burnt out then it is very likely to have damaged the main circuit board.
Re: all lights flashing!!!!
Have you looked at the pump filter yet?
If the pump has burnt out then it usually has obvious signs of burning on the pump windings.
A new pcb will cost around £100, it will need programming with a one use only smart card at £20 but to use the card you will need a card reader, around £100+.
One of the many reasons that the trade does not share your affection for Indesit appliances. 😉
Re: all lights flashing!!!!
Lights 1,2 & 4 is supposed to be F11, drain pump cannot be activated. Check for pump blockages by removing and cleaning the pump filter. Shine a torch inside to make sure there is no obstruction.
If all clear the the pump wiring or even the main pcb could be faulty. I have seen pumps burn out on these and take out the main pcb. 🙁Re: all lights flashing!!!!
Moved to correct forum. 😉
You must have had some shockers in the past then. :rolls:
The error codes are given by the lower five vertical lights on the right, ignore the flashing lights. Lights number from BOTTOM to TOP, lowest light being 1.
Not at home ATM , visiting family so only have my iPad. All the error codes are listed at the to
of the forum, will try and locate if you can’t find it.Re: Hotpoint bwd129 error
You can sometimes get a button or very small coin that will block the hoses, if it turns edge on the water will flow past but if it turns face on it will stop the water.
Re: Difference between Hotpoint WMUD 942 and Hotpoint WMD 94
Must be incorrect, there are several versions of both models with different pcb’s and at least one model of WMUD has three different modules on it’s own.
Full commercial code, full model number inc suffix letters and serial number needed to be certain.
Re: Vehicle
I don’t uplift machines at any time but I did once go to Luton and back before 1.00PM in this car to bring back an ISE 10 washing machine and an ISE dryer for my daughter, thanks again Bryan (r600a) 8)
