Forum Replies Created
-
Posts
-
Re: I bought an ISE 10
Martin wrote:
iadom wrote:
So you knew right from the start that the ISE project was flawed and therefore had nothing whatsoever to do with them?Yes and yes 😀
So you didn’t have an early ISE on test, didn’t help to re write the user manual, didn’t get paid by K Heath for this help and input?Before you answer that, do you still have access to THIS forum? I do and it makes your statement above duplicitous at the very least.:)
Re: I bought an ISE 10
Martin wrote:The whole ISE project was a comedy from start to finish. A tragedy though for the many who bought into the so called ‘ethos’.
So you knew right from the start that the ISE project was flawed and therefore had nothing whatsoever to do with them?
Re: What Really Happened
As you say, amusing, it seems you are now the Messiah. :rotfl: :worthy:
Martin will have ‘seen’ the ISE 10 at meetings but won’t have seen inside one.
Re: No Water coming from upstairs tap to washing machine
Call a plumber. 😉
The likeliest cause is a faulty tap.
Re: I bought an ISE 10
ajsdoc wrote:So do you think the quality if the ISE 10 machine has been misrepresented
No.
Re: What Really Happened
I see that Martin has dug out his large wooden spoon again. Sh*t Stirrer :rolls:
Not sure if he has ever worked on an ISE 10 machine to start with, also didn’t he have some involvement with re writing the very first ISE manuals, wasn’t he given a machine to test to assist him in this? Hardly the actions of someone who purports to have ‘seen through’ ISE from the start. 🙁
Re: Hotpoint WMD960 not rotating
The motor needs testing with a megger or suitable multimeter, also all the wiring harness and connections need inspecting for breaks or bad contacts.
Re: Hotpoint HVL 211 – weird clicking, video embedded…
Worth checking the motor carbon brushes for wear and also look for loose motor wiring connections.
Re: Indesit WIE 1375 washing machine fault code
From memory of some posts a good while back this could be a failure of the condensation sensor. I have never encountered the fault or seen a condensation sensor but I’m sure I have read that they were fitted for a short time to some machines. I don’t know if it is possible to bypass this component. :con:
Is the machine in a damp environment? If it is then a gentle blast of warm air from a hairdryer or similar from underneath may help. Tilt the machine back against a wall to do this, get someone to hold the machine and do not tip it back more than 35 degrees.
AFAIK = as far as I know. 😉
FYI correct model No: WIE137S ( for your information ) 😀
Re: indesit dif 16 3 lights flashing
If you get a humming noise then the first thing to check is that the inlet water tap is turned on. Could it have frozen over the weekend, it did go very cold on Saturday night?
The water turbine/air break is behind the left hand ( from front ) side panel. A squarish, translucent plastic doofer. Fairly easy to change if needed but check the water inlet first of all.
