Forum Replies Created
-
Posts
-
Re: independant training
Deffinateley Graham Dixon, I started by attending one of his courses about 6 years ago and its a really good course.
Re: Maytag tumble dryer
I almost sure access is through the bottom panel at the front, thermal fuse is just behind duct cover.
Re: American Whirlpool fridge Fridge freezer ‘CF’ Error.
The whirlpool fault code description says:
Code “CF” blinking on the freezer display, RED alarm LED blinking and buzzer ON.
Communication failure between Main Board and User Interface.
Verify the connections.Replace the User Interface and if the problem persist to replace the Main Board.
It is also worth checking the connector at the top of the freezer door under the hinge cover, not unusual to have a bad connection on these causing this problem. If not its maybe a dodgy board, I have had a few in the past.
Chay
Re: whirlpool 3RLEQ8033SW1 dryer
I have got a bulletin somewere about a wiring fault on these machines causing this problem, i will try and dig it out and forward it to you.
The fault was only on these newer machines, they were wired up wrong apparantley in production!Re: whirlpool f/f s20drbb32-a/g (858615815000)
it will be rear pcb, common fault:
481221778217
Cheers,
Chay
Re: whirlpool w/m
that 12nc and Model number is for a fridge freeezer??
In any case whirlpools (especially recent models) are a nightmare for going out of balance, really sensitive.Re: whirlpool SXS 20RBD4A+PT
No Im sure your model only requires rear board. I would check the bi-metal stat on defrost heater, they sometimes pop-apart, check the de-frost heater is working as if not it gives the exact fault you are describing.
If you dispense the ice or water does the led display flash? If it does you will need a front board, the fron board does control various components.
Hope this helps,
ChayRe: whirlpool TL washer
Hi John,
You can get the capacitor as spare part:
481912118185 – £10.50 @ Masterpart
Id check the pump hasnt jammed or gear box seized first though as its unusual for capacitors to go pear shaped on toploaders.
Re: whirlpool AKZ2516nb f03 fault
Re-programming with a SAM Module sometimes works but normally its a new board, pain because they cost a packet.
Re: Whirlpool american
You need to replace the front board, that will stop it. Depending on the serial number you may need front and back board. 😯
Re: whirpool cut out
Hi John,
I think the one you need is:
481925228095
In stock at Masterpart @ £5.80
Chay
