Forum Replies Created
-
Posts
-
Re: Hotpoint ffa71 Sensors
Its a system fault, they are prone to leaking from the anti condesation loop around the freezer door, they used ferrous metal pipework for the loop seems the joints have been breaking down, cutting out the loop and regassing sometimes cures but will may cause condesation around the freezer compartment
Re: hotpoint FF72P fault code
Just a thought do you have Fridge door plastered with fridge magnets, as this can cause funny faults on these, i had the very same fault many moons ago i tried a new baffle, module etc and the fault still showed, in desperation i phoned the boffins at techinical and was advised to remove the magnets, the fault then cleared never been back since. jj
Re: Indesit WIA111(UK) Door lock light keeps flashing
G/teed board fault its the programe selector sw thats faulty jj
Re: Hotpoint Dishwasher BFI 620 Bad Leak
If it is the curved plastic spray arm i have had them splitting and leaking, i usualy replace withe the straight metal one.
Re: Hotpoint WF540 – F10 fault
Normaly the pressure sw but can be the module, got one tomorrow tried a press sw but still showing F10 going back with a module fingers and toes crossed, i’ll let you know outcome tomorrow JJ
Re: Depreciation on assets (van) and capital allowances
I think it is 40 percent the 1st year then 20 percent each year after that.
Re: Van logo
I dont think you can use the actual logos, but they cannot do you for plain text a couple of pictures of appliances helps as that catches the eye and says what you are all about, i’ve had my money back for the sign writing within weeks.
Re: WD440 Blowing dryer elements!
Check the heater is not coming into contact with the metal deflector if it is it can cause a hot spot on the element and they blow JJ
Re: Hotpoint WD420 Error F08
Could be the wash heater down to earth or pressure switch, i tend to find most of them are heater to be honest, jj
Re: Ariston Fridge Freezer MBA 3842c UK Fridge Not Cooling
If the Freezer is okay and the fridge is to warm it sounds like a thermistor problem which is not replaceable, there is however a timed control module part n/o C00262537 to overcome this problem, i have fitted a few of them and it works okay on most the time only one i had a problem with was a F/freezer in a big house it was situated in a annexe with no heating as the ambiant temp was low, and the module relied on time the fridge then started running to cold. Cheers JJ
Re: Connect Prices
£38.42 from connect and £56 from qualtex for me not found it from masterpart though.
Re: Hotpoint WT721 whole display kept flashing
As there is 3 varaints, i would guess the pcb’s you are getting from EMW are the wrong one for the machine you have, i’ve programed machines thinking it was the right files i’ve dowloaded only to realise later it was the wrong one, its a nightmare trying to figure out which is which at times.
