Forum Replies Created
-
Posts
-
Re: WMA35
Bosch motor when brushes wear 70{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the time blows the module.
Re: Hpt Motor Conversion Problem.
The old analogue motor you have to make sure the wash speed is set up correctlty also as it will cause excessive noise and banging about, there was a strobe disc to set it, i used to just count the amount of times each paddle struck the water you adjust screw on back of tacho, i set speed to approx 33 strikes which worked out at about 56 rpm.
Re: Indesit Franchise
There is a member on this site who went on the franchise route, he gradualy built up his private work to the extent he needed to cut down on franchise work but they werent keen on this, to the extent he told them to stuff it!!but he for one was glad he did it to give him a bit of security to get started, mind you he isn’t a dummy he one of the best engineers in this kneck off the woods.
Re: another indesit pls help
I take it you have checked the inlet valves??? they fill to prime the sump on one valve then change over to the other after short pump out i would guess it is nothing more than an open circuit solenoid. JJ
Re: Hotpoint BF162 DW aborting program
Be the heater prob’ly down to earth, you will find inlet valve faults more than 90{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} time are heater related.
Re: hotpoint DWF50P NO HEAT
Always the module i’ve found, if they carry on right through the programe not heating some dont open dispenser as well sure fire giveaway.
Re: Hotpoint wm67
You only need a simple circuit tester to check a solenoid if it is open circuit , the ans to your question probl’y yes.
Re: Hotpiont WD860P – motor connector block & crimp tool
The rast plug from the older mahines fit in perfect if i’m stuck i use the plug from the 1604796 digital fix kit.
Re: hotpoint dwf40p dishwasher
ROHS is only to identify electrical and electronic parts that pass the WEE directive by removing contaminating materials, the earlier part will fit okay.
Re: I ripped their floor vinyl.
Try cutting the shaft of a broom handle about 600mm or buy a bit dowling slightly thicker from a hardware store fit a piece of string to it, lift front of machine slip it under and roll machine out when putting it back use the string to retrieve it, doesnt work on machines jammed right under work top but works okay on most.
Re: VTD 00
3 = Grey
4 = Brown/White
5 = Pink/WhiteTo change belt you only need to remove right hand side panel remove console and screw behind console move front panel forward slip belt on replace console and screws stretch belt on with special tool, refit side panel 10 to 15 mins tops.
