Forum Replies Created
-
Posts
-
Re: Td Drum rubbing
Eh! who do you work for? i think i’ll give up helping on this site with t^ts like you about.
Re: Td Drum rubbing
I have in writing on a Q & R bulletin, i like you was throwing them away until this came out.
Re: Td Drum rubbing
If you are fitting the 1703662 drum to a back panel with square rear bearing the washer stays if to the tear drop back panel it doesnt.
Re: Indes**t wie 167 uk
Unpluging machine for 10 mins, sometimes cure if not check for dampness on module a blow with a hairdryer usualy cures.
Re: CREDA Double Oven 48149V
As A1 says all stats overshoot required temp, to check temp you have to to take readings of a couple of cut outs and cut ins and work out average temp and you will find you are there or there about+or – 5 to 10′ C which is acceptable.
Re: Hotpoint Power module question.
If it has a the transformer on it, its a straight swap cheers jj
Re: Hotpoint Power module question.
Jim i take it this module doesnt have a transformer and the one on the machine does, if so there is a kit 1603283 which comes whith wiring an earth clip and some locating pegs for the new module, you remove earth from the motor cutting at the spade conection on the console, the earth wire from the kit is attached to the motor and using the clip supplied clamped to the cabinet next to the motor all the wiring is identical otherwise.
Re: Hotpoint FDW70P D/W SN 510181239
They changed the 9900250 clips they are wider and are hopeless there is another part no for them i’ll dig it out later.
Re: indesit widl126s
Check for blockages in condensor, fan motor etc, all the things that normally blow one shots in driers.
Re: Hotpoint Aqualtis AQXXD169PM
The Aqualtis has been out about a year now, and i’ve seen 3 one needed a pressure switch, another was a blocked pump and the 3rd one was a smashed door in Curry’s done in transit, going by the amount being sold and talking to other engineers they seem to be a reliable machine.
