Forum Replies Created
-
Posts
-
Re: Hotpoint DWF70 despair
Check the pressure hose i’ve had a few with water trapped up it causing an airlock.
Re: Hotpoint WD News
Not now they don’t, they come with 1 hose with a built in y piece that is attached to both valves.
Re: Creda Spacesaver D/Wash – no heat
Prob’ly be resetable trip on heater tripped, probable cause a blockage in pressure system, check pressure hose and for gunge in pressure chamber which can be accessed below the filter in tub heater is situated on the right hand side.
Re: Hotpoint Aquarius WF000G not hot filling
I hope you didnt pay a lot for your module, as it sounds like a fill problem the hot valve is only top up once reaching wash level. I’ll give you a clue did you check both cold solenoids.
Re: sat nav
Gat a cheap and cheefull Garmin i3 wouldnt be without it had it over a year now Best £99 i’ve ever spent, even out in the sticks its either spot on or within a 100 or so yards.
Re: wma9 bearings
If they arent to rusty give them a couple of good wacks with a drift and 80{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the time you can remove with a torx bit on an extension bar.
Re: WMA30P – JUST STOPS!!
If you have had a new drum it should be good for a few more years yet, more than likely brushes, be a pity to scrap it for something like that.
Re: Indesit WIE157s
The module has altziemers i’m afraid, i.ve got the luxury of reprograming, you will need module and eeprom that model has a 5 year parts g/tee by the way.
Re: I Need A New Insulation Tester, But Not Too Expensive
Try ebay seen some good meggers at decent prices.
Re: Hotpoint condenser dryer ctd00p
I had one the other week and the return pipe from the water tank was split, cuasing water to leak onto pump terminals blowing the pump windings and the timer also, same fault red neon on but no pump to pump water.
