Forum Replies Created
-
Posts
-
If you post the full model number up and there is also a number on the appliance starting with 7 and the serial number I can see if there is any info I can get on it or someone else can get on it
Might be worth reading the manual as if you use dishwasher tablets the cycle is also longer as it takes time to dissolve the tablet as that’s a explanation I had from beko technical
Ahrer with dave on this try on timed dry if it’s the same will definitely be blocked condenser or air flow issue
If it has a small relay pcb on the back that’s what supply’s power to the elements so I would check that
I would contact hoover part number may have change why do you need facia is it because the screen has pressed in and won’t start
Think you may be confusing this vented model with a condenser dave I can’t see a idler pulley on the drawing,sounds like rear bearing has failed and the shift is running on the back panel
Sounds like the rear bearing may have failed and caused more problems unplug machine and at the rear there is a half moon plastic cover this is secured with 2 screw take this off is where I would start
Well checking that the motor is plugged in and that the door lock is plugged in is where I would start
Why didn’t the hotpoint repair man fully test the machine to make sure it was functioning properly, I would start with the door lock if that’s fine it maybe a fault in the wiring to the motor or the plug to the motor has come loose
Yes the top need to come off, if it’s the 1 for the oven maybe the small common 1 that beko and rangemaster use
