Forum Replies Created
-
Posts
-
Think the Model maybe a bit wrong Si4858cix the 1s are supposed to be I, s
I would be looking at fan motor part number C00398229Think dave is spot on only thing that I would add is to give the condenser a good clean from all angles and when the condenser is out put your hand in the back and clean the fluff build up
The heater will get 240v from the pcb so if its not getting it the pcb may be faulty but its worth checking the wiring in the door to check if there’s a broken wire
The E01 fault is related to the door lock so check wiring and door lock or it says check triac on pcb
I have never changed a beko brushless induction motor I have changed the motor pcb thou, so surprised you heard that the motors fail dave
They are really tight it’s the adhesive they have used the way I found get the drum to release is easing a flat blade screwdriver in where the heater sits,a tip on fitting new belt which you may well need is to loosen the motor bolts slightly hope this helps you
There are 2 on the left hand side that are bolted through the cabinet similar to the hotpoint and indesit type and the normal beko type on the right hand side 1 of them
Most faults on vestel built dishwashers are the eco switch which is part of the diverted valve in picture double check this is the 1 fitted as vestel have many different 1s fitted
